5
Getting Started
English

Connecting the AM Antenna

Rear Panel of the Unit

Even when connecting an outside AM antenna, keep the indoor AM loop connected.
CAUTION:
To avoid noise, keep antennas away from the System, the connecting cord and the AC power cord.

Connecting the Speakers

Connect the right speaker to the RIGHT speaker terminals and the left speaker to the LEFT speaker terminals. “Right” / “Left” is labeled
on the rear of the speaker.
1. Open each of the terminals to connect the speaker wire leads.
2. Connect the speaker cords to the Speaker terminals of the Unit.
Connect the gray (+) and gray with black stripe (–) cords of the right side speaker to the red (+) and black (–) terminals marked RIGHT
on the System.
Connect the gray (+) and gray with black stripe (–) cords of the left side speaker to the red (+) and black (–) terminals marked LEFT on
the System.
3. Close each of the terminals.

CAUTIONS:

A TV may display irregular colors if located near the speakers. If this happens, set the speakers away
from the TV.
Use speakers with the correct impedance only. The correct impedance is indicated on the rear panel.
AM loop antenna (Supplied)
Attach the AM loop to its base by snapping the
tabs on the loop into the slot in the base.
Turn the loop until you
have the best reception.
AM antenna wire (not supplied)
If reception is poor, connect the outside antenna.
Right side (rear view) Left side (rear view)
Gray with
black stripe
Gray
Gray with
black stripe
Gray
LVT1346-001A_E.book Page 5 Wednesday, May 4, 2005 11:38 AM