Rear Panel
N/A TxRx
1 2 3
NOTE: Connect a ground wire between the DVC and the computer or control system.
Ground ( |
| ) |
| Transmit (Tx) | |
|
| ||||
Receive (Rx) |
|
| |||
|
| ||||
|
| ||||
Transmit (Tx) |
| Receive (Rx) | |||
| |||||
|
NOTE: If you use cable that has a drain wire, tie the drain wire to ground at both ends.
Computer or Control System
Figure 5. Connecting to the RS-232 Port
In the “Remote Configuration and Control” section, see “Using SIS Commands” for information on sending SIS commands to this port.
Connecting to the USB Config Port
The mini Type B USB Config port is located on the DVC front panel. It can be used to configure the converter via SIS commands.
1.Use a USB
CONFIG
Mini Type B | Type A |
USB | USB |
USB
Ports
USB Cable
MENUADJUST
NEXT
Extron
Converter Front Panel
DVC SERIES
DIGITAL VIDEO CONVERTER
Computer
Figure 6. Connecting to the Config Port
DVC 501 SD • Installation | 6 |