Rack mounting procedure
To rack mount the converter, you can use one of the Extron 19 inch rack shelf mounting options (see “Optional Accessories,” earlier in this section, for part numbers).
false front panel uses 2 front holes.
DIGITAL
C | 501 |
|
DV | SD | |
VIDEO |
| |
CONVERTE | ||
|
| R |
(2)
Figure 27. Rack Mounting the DVC 501 SD
1.If rubber feet have been installed on the bottom of the unit, remove them.
2.Mount the DVC on the rack shelf using two
(diagonal) corners to secure the unit to the shelf.
3.(Optional) Attach a blank panel or other unit to the rack shelf.
4.Insert the shelf into the rack, aligning the holes in the shelf with those in the rack.
5.Secure the shelf to the rack using the supplied machine screws. This shelf can be mounted in the front or in the rear of the rack.
Under-desk Mounting
The DVC 501 SD can also be mounted under furniture, such as a table or podium surface, using the optional MBU 125
1.If rubber feet were previously installed on the bottom of the unit, remove them.
2.Attach the mounting brackets to the unit with the included machine screws.
3. Insert #8 wood screws into the four pilot holes. Tighten each screw into the mounting surface until slightly less than 1/4 inch of the screw protrudes.
4. Align the mounting screws with the slots in the brackets, and place the converter against the surface with the screws through the bracket slots.
5.Slide the unit slightly forward or back, then tighten all four screws to secure it in place.
DVC 501 SD • Reference Information 30