ADJUSTMENT OF PROJECTION POSITION (Refer to Fig. 5)
1. Carry out horizontal and vertical adjustments as follows:
(1)To adjust the horizontal position of the screen, loosen rotary setscrews [E] (there are two pieces on both sides) and 4 hexagon socket bolts (M5 × 10), and rotate the projector horizontally.
(2)To adjust the vertical position of the screen, loosen the assembling bolts (there are 4 pieces on both sides), then tilt the front of the projector vertically.
2.Tighten the rotary setscrews [E], hexagon socket bolts (M5 × 10), assembling bolts, and fix the LCD projector.
Fig. 5 ADJUSTMENT
Hexagon wrench
(accessory)
Rotary setscrew [E] 
Assembling bolt for M8
Tip of LCD Projector ~ Center of ceiling plate | 148 |
Lens center
Tilt adjusting latitude of 15 degrees
126.2
Assembling bolt (M8 × 25)
339
367
405 | 453 |
48
Unit of indicated dimensions (mm)
FILTER CLEANING (Carry out filter cleaning with appropriate intervals)
Before replacing the filter, never forget to turn OFF the main power switch and unplug the power cord from the outlet.
Fig. 6 REPLACEMENT
1. Remove the 2 filter guard fixing screws, and remove the filter guard.
2. Push the knob of the filter cover in the direction indicated by the arrow mark, and raise it.
3. Take out the filter, wash it well in water or synthetic detergent, and dry it completely.
4. Set the filter on the filter cover, and install the filter cover on the body.
5. Tighten 2 filter guard fixing screws, then set the filter guard.
Filter guard |
Filter cover |
2 filter guard |
fixing screws |
Filter |
VICTOR COMPANY OF JAPAN, LIMITED
Printed in Japan 0999YMPS/VP
– 4 –
