![](/images/new-backgrounds/1140887/140887133x1.webp)
TROUBLESHOOTING ![](/images/new-backgrounds/1140887/140887133xi2.webp)
![](/images/new-backgrounds/1140887/140887133xi3.webp)
![](/images/new-backgrounds/1140887/140887133xi4.webp)
![](/images/new-backgrounds/1140887/140887133xi5.webp)
![](/images/new-backgrounds/1140887/140887133xi6.webp)
EN 67
If, after following the steps in the chart below, the problem still exists, please consult your nearest JVC dealer.
| SYMPTOM |
| POSSIBLE CAUSES |
| CORRECTIVE ACTION |
1. | No power is supplied. | 1. •The power is not connected |
| 1. •Connect the AC Adapter | |
|
|
| properly. |
| securely (☞ pg. 10). |
|
|
| •The battery is dead. |
| •Replace the dead battery |
|
|
| •The LCD monitor is not |
| with a fully charged one |
|
|
| open fully or the viewfinder |
| (☞ pg. 9). |
|
|
| is not pulled out when |
| •Open the LCD monitor |
|
|
| recording. |
| fully or pull out the |
|
|
|
|
| viewfinder. The LCD |
|
|
|
|
| monitor turns on/off when |
|
|
|
|
| it is opened/closed at |
|
|
|
|
| approx. 90° while the |
|
|
|
|
| Power Dial is set to any |
|
|
|
|
| position except “OFF” if the |
|
|
|
|
| viewfinder is not fully |
|
|
|
|
| pulled out. |
2. | Recording cannot be | 2. •The tape’s record safety tab |
| 2. •Set the tape’s record safety | |
| performed. | is set to “SAVE”. |
| tab to “REC” (☞ pg. 12). | |
|
|
| •The Power Dial is set to |
| •Set the Power Dial to “ A ”, |
|
|
| “PLAY”. |
| “ M ”, “5S” or “ ” |
|
|
| •“TAPE END” appears. |
| (☞ pg. 18). |
|
|
| •The cassette's cover is open. |
| •Replace with new cassette |
|
|
|
|
| (☞ pg. 12). |
•Close the cassette's cover.
3.There is no playback picture.
3.•The camcorder is not getting power, or some other malfunction exists.
3.•Turn the camcorder’s power off and on again (☞ pg. 19).
4. | Some functions are not | 4. | •The Power Dial is set to | 4. | •Set the Power Dial to any |
| available using the MENU |
| “ A ”. |
| position except “ A ” |
| button. |
|
|
| (☞ pg. 18). |
5. | Some functions are not | 5. | •The Power Dial is set to | 5. | •Set the Power Dial to any |
| available using the Select |
| “5S” and “ A ”. |
| position except “5S” and |
| Dial. |
|
|
| “ A ” (☞ pg. 18). |
6. | The focus does not adjust | 6. | •Focus is set to “MANUAL”. | 6. | •Set Focus to “AUTO” |
| automatically. |
| •The recording was done in a |
| (☞ pg. 44). |
|
|
| dark place, or the contrast |
| •Clean the lens and check |
|
|
| was low. |
| the focus again (☞ pg. 72). |
•The lens is dirty or covered with condensation.
7.The cassette won’t load properly.
7. •The cassette is in the wrong | 7. •Set it in the right position |
position. | (☞ pg. 12). |
•The battery’s charge is low. | •Install a fully charged |
| battery (☞ pg. 8). |
8. Play, Rewind and | 8. •The Power Dial is not set to | 8. •Set the Power Dial to |
“PLAY”. | “PLAY” (☞ pg. 49). |
don’t work.
9.The tape is moving, but there’s no picture.
9.•Your TV has AV input terminals, but is not set to its VIDEO mode.
•The cassette’s cover is open.
9.•Set the TV to the mode or channel appropriate for video playback (☞ pg. 56, 57).
•Close the cassette's cover (☞ pg. 12).
10.In the
10. •The | 10. •Select “5S” or “5SD” in the |
System Menu is set to | System Menu (☞ pg. 35). |
“ANIM.”.
CONTINUED ON NEXT PAGE