JVC 0997TOV*UN*SN manual SET EDIT-IN Point, SET EDIT-OUT Point, USE P.AE/EFFECT if Necessary

EN 61

	M
A	5S
OFFY
A
L
P

Power Dial

Remote sensor

RM-V711U (provided)

		Program
		IN	OUT	MODE
1	– – – – : – – ~

2~

3~

4~

5~

6~

7~

8~

T W

TIME CODE	– – : – –
TOTAL	0 0 : 0 0

Random Assemble

Editing Menu

FADE/WIPE	PLAY
EFFECT
	R.A.EDIT ON/OFF
EDIT IN/OUT

4 SET EDIT-IN POINT

At the beginning of the scene, press EDIT IN/ OUT on the remote control. The Edit-In position appears on the Random Assemble Editing Menu.

5 SET EDIT-OUT POINT

At the end of the scene, press EDIT IN/OUT. The Edit-Out position appears on the Random Assemble Editing Menu.

6 USE FADE WIPE ON SCENE TRANSITION (IF NECESSARY)

Press FADE/WIPE.

•Cycle through the effects by pressing repeatedly, and stop when the one you want is displayed.

•If you select a Fade/Wipe effect for an Edit-Out point, the effect is automatically applied to the following Edit-In point.

•You can’t use a Picture Wipe/Dissolve at the end of the last scene.

•When you use Fade/Wipe effects, that time is included in the total time (this does not apply to Picture Wipe/Dissolve).

7 USE P.AE/EFFECT (IF NECESSARY)

Press EFFECT.

•Cycle through the effects by pressing repeatedly, and stop when the one you want is displayed.

•You can use Classic Film, Monotone, Sepia, Strobe or Video Echo effects.

•If you're not using Fade/Wipe or P.AE/Effects, repeat steps 4 and 5 only.

NOTES:

●When the source tape has more than 2 identical time codes (☞pg. 21), the camcorder may not find the Edit-In point you chose and a malfunc- tion may occur.

●When choosing a scene, set Edit-In and Edit-Out points so there’s a relatively large difference between them.

●If the search time for an in-point exceeds 5 minutes, the recording deck’s Record-Standby mode will be cancelled and editing will not take place.

●If there are blank portions before or after the Edit-In and Edit-Out points, a blue-backed screen may be included in the edited version.

●Since time codes register time only as accurately as seconds, the time code total time may not match the total program time exactly.

●Turning off the camcorder’s power erases all registered Edit-In and Edit-Out points.

●If you use Sepia or Monotone P.AE/Effects, you can’t use the Dissolve or Black & White Fader. In this case the Dissolve or Black & White indicator begins blinking. Once the next Edit-In point is registered, the effect is turned off. To combine these effects, use Sepia or Monotone during recording, then use Dissolve or Black & White Fader during Random Assemble Editing.

CONTINUED ON NEXT PAGE