JVC LYT1528-001B, 0206ASR-NF-VM manual Data Battery System, Maximum continuous recording time

14 EN GETTING STARTED

To detach the battery pack		Using The Battery Pack
Slide the battery pack upward while pressing
		Perform steps 2 – 3 in “Charging The Battery
PUSH BATT. to detach it.
		Pack”.
Battery pack	Charging time	Maximum continuous recording time
BN-VF707U*	Approx. 1 hr. 30 min.
BN-VF714U	Approx. 2 hrs. 40 min.	Battery pack	LCD monitor	Viewfinder on
			on
BN-VF733U	Approx. 5 hrs. 40 min.
		BN-VF707U*	1 hr. 30 min.	1 hr. 40 min.
* Provided
		BN-VF714U	3 hrs.	3 hrs.25 min.
NOTES:
		BN-VF733U	7 hrs.	8 hrs.
● This product includes patented and other
		* Provided
proprietary technology and will operate only
		NOTES:
with JVC Data Battery. Use the JVC BN-
VF707U/VF714U/VF733U battery packs. Using		● Recording time is reduced significantly under the
generic non-JVC batteries can cause damage		following conditions:
to the internal charging circuitry.		• Zoom or Record-Standby mode is engaged
● If the protective cap is attached to the battery		repeatedly.
pack, remove it first.		• The LCD monitor is used repeatedly.
● During charging, the camcorder cannot be		• The playback mode is engaged repeatedly.
operated.		• The LED Light is used.
● Charging is not possible if the wrong type of		● Before extended use, it is recommended that you
battery is used.		prepare enough battery packs to cover 3 times the
● When charging the battery pack for the first time		planned shooting time.
or after a long storage period, the POWER/		ATTENTION:
CHARGE lamp may not light. In this case, remove
		Before detaching the power source, make sure that
the battery pack from the camcorder, then try
		the camcorder’s power is turned off. Failure to do so
charging again.
		can result in a camcorder malfunction.
● If a fully charged battery pack is attached to the
		Data Battery System
unit, the POWER/CHARGE lamp does not blink to
indicate that charging is not performed.
● If the battery operation time remains extremely		You can check the remaining battery power and
short even after having been fully charged, the		the recordable time.
battery is worn out and needs to be replaced.		1) Make sure the battery is attached and the
Please purchase a new one.		Power Switch is set to “OFF”.
● Since the AC Adapter processes electricity		2) Open the LCD monitor fully.
internally, it becomes warm during use. Be sure to		3) Press DATA, and the battery status screen
use it only in well-ventilated areas.
		appears.
● Using the optional AA-VF7 Battery Charger, you
		● It is displayed for approx. 3 seconds if the
can charge the BN-VF707U/VF714U/VF733U
		button is pressed and released quickly, and for
battery pack without the camcorder.
		approx. 15 seconds if the button is pressed
● After 5 minutes has elapsed in Record-Standby
		and hold for several seconds.
mode with the cassette inserted and no operation
		● If “COMMUNICATION ERROR” appears
is performed (“PAUSE” indicator may not appear),
the camcorder will automatically turn off its power		instead of the battery status even though you
supplied from the AC adapter. In this case, the		tried to press DATA several times, there may
battery charge starts if the battery is attached to		be a problem with your battery. In such a case,
the camcorder.		consult your nearest JVC dealer.