Quick Review, Still Playback | JVC 0206ASR-NF-VM, LYT1528-001B

NOTES:

●The time code cannot be reset.

●During fast-forwarding and rewinding, the time code indication does not move smoothly.

●The time code is displayed only when “TIME CODE” is set to “ON”. ( pg. 34)

Quick Review

Enables to check the end of the last recording.

1)Press QUICK REVIEW during the Recording- Standby mode.

2)Tape is rewound for about several seconds and played back automatically, then pauses in the Recording-Standby mode for the next shot.

● Distortion may occur at start of playback. This is normal.

1)Play back a tape or use Blank Search

( pg. 22) to ﬁnd the spot at which you want to start recording, then engage the Still Playback mode. (See the right column.)

2)Set the Power Switch to “REC” while pressing down the Lock Button located on the switch, then start recording.

	1 Load a cassette. ( pg. 18)
	2 Set the VIDEO/MEMORY Switch to “VIDEO”.
	3 Set the Power Switch to “PLAY” while
	pressing down the Lock Button located on the	PLAYBACK
	switch.
	4 To start playback, press 6.
	5 To stop playback, press 7.
	● During Stop mode, press 1 to rewind, or ¡ to	&
	fast-forward the tape.	&
	fast-forward the tape.	RECORDING
	To control the speaker volume
	Slide the Power Zoom Lever (VOL. +/–) towards
	“+” to turn up the volume, or towards “–”to turn
	down the volume.
	down the volume.	VIDEO
	NOTES:
	● The playback picture can be viewed in the LCD
	monitor, viewﬁnder or on a connected TV.
	( pg. 23)
	● If Stop mode continues for 5 minutes when power
	is supplied from a battery, the camcorder shuts off
	automatically. To turn on again, set the Power
	Switch to “OFF”, then to “PLAY”.
	● When a cable is connected to the AV connector,
	the sound is not heard from the speaker.

Pauses during video playback.

1)Press 6 during playback.

2)To resume normal playback, press 6 again.

● If still playback continues for more than about 3 minutes, the camcorder’s Stop mode is automatically engaged.