JVC LYT1776-001A manual Power, Charging The Battery Pack, To detach the battery pack

Getting Started EN 11

Power

Charging The Battery Pack

1 Set the Power Switch to “OFF” ( 9).

2Open the battery cover.

Press “w OPEN” and slide the battery cover off the camcorder in the direction as illustrated below.

3Attach the battery pack.

With the “r” (arrow) on the battery pack pointing at the correct direction, insert the battery pack until it locks in place.

•Re-attach the battery cover. (For BN-VF808U only)

r Arrow

AV

DC

4Connect the AC adapter.

DC connector

AC Adapter

To AC Outlet

(110V to 240V)

•“” blinks to indicate charging has started.

•When the lamp goes out, charging is

fi nished. Unplug the AC adapter from the AC outlet and disconnect the AC adapter from the camcorder.

To detach the battery pack

Slide and hold battery release button BATT. ( 9), then remove the battery pack.

Charging/recording time (approx.)

	Required	Maximum
Battery pack		Continuous
	charging time	Recording
		Time
BN-VF808U	1hr. 30 min.	1 hr. 55 min.
(Provided)
BN-VF815U	2 hrs. 40 min.	3 hrs. 45 min.
BN-VF823U	3 hrs. 50 min.	5 hrs. 40 min.

Notes:

•If a fully charged battery pack is attached to

the unit, “” lamp will blink for approx. 10 seconds before it turns off.

•Since the AC Adapter processes electricity internally, it becomes warm during use. Be sure to use it only in well-ventilated areas.

•After 5 minutes have elapsed in Record- Standby mode with the cassette inserted and no operation is performed, the camcorder will automatically turn off its power supplied from the AC adapter. In this case, the battery charge starts if the battery is attached to the camcorder.

•Please do not pull or bend the AC adapter plug and cable. This may damage the AC adapter.

Using The Battery Pack

Perform steps 2 – 3 in “Charging The Battery Pack”.

Notes:

• Recording time is reduced signifi cantly under the following conditions:

• Zoom or Record-Standby mode is engaged repeatedly.

• The playback mode is engaged repeatedly.	ENGLISH
• Before extended use, it is recommended that
you prepare enough battery packs to cover 3
times the planned shooting time.
Attention:
Before detaching the power source, make sure
that the camcorder’s power is turned off. Failure
to do so can result in a camcorder malfunction.