JVC MP-XP7220KR service manual CN2 B

MP-XP7220KR,MP-XP5220KR

1.1.3 Removing the top case and LCD panel assembly (See Figure 1 and Figure 5 ~ Figure 8)

•Prior to performing the following procedure, remove the key- board assembly.

(1)Insert a single-slotted screwdriver or a flat screwdriver in a space b on the underside of the hinge cover. Then, remove the hinge cover by pulling the screwdriver in the direction indicated by the arrow.

And then, remove one more hinge cover at the other side of the main body.

(2)Remove the four screws B attaching the top case.

(3)Remove one screw C (short) and one screw D (long) at- taching the shield plate.

(4)Reverse the main body, and remove the four screws E on the bottom of the main body. (See Figure 1)

(5)Disconnect the connector wire from the connector CN2 on the mother board. Similarly, remove the connector wires from the connectors CN3, CN5, and CN7.

(6)Remove one latch c on the rear side of the main body, and release the two joints d while moving the top case in the rear direction.

Hinge cover

Space b

Fig.6

CN2 B C Shield plate

CN3
D
B
B	Latch c
	Fig.7
CN7	Top case

CN5 B Top case

Fig.5

Bottom case	Joint d
	Fig.8

(No.G1004)1-3