JVC MX-JE31, MX-JE5 manual Setting the Clock Main Unit, Turning Off the Power Automatically Remote

GAMMA	Adjust if the neutral color is bright
	or dark (–3 to +3).
BRIGHTNESS	Adjust if the picture is bright or
	dark as a whole (–8 to +8).
CONTRAST	Adjust if the far and near positions
	are unnatural (–7 to +7).
SATURATION	Adjust if the picture is whitish or
	blackish (–7 to +7).
TINT	Adjust if the human skin color is
	unnatural (–7 to +7).
SHARPNESS	Adjust if the picture is indistinct
	(–8 to +8).

3Adjust the parameter.

4Repeat steps 2 to 3 to adjust other parameters.

To erase the screen, while holding down SHIFT, press VFP again. The screen will automatically be erased after 9 seconds even if you do not press VFP.

Changing the Display Brightness	ONLY
	Remote
You can dim the display window.
DIMMER ON
DIMMER OFF
(Normal)
Setting the Clock Main Unit	INFO
ONLY

Without setting the built-in clock, you cannot use Daily/ Recording Timers (see page 34) and Sleep Timer (see next column).

•To exit from the clock setting, press CLOCK/TIMER as required.

•To go back to the previous step, press CANCEL/DEMO.

1Activate clock setting mode.

CLOCK /TIMER

2Adjust the hour, then minute.

PRESET SET

/DISPLAY

Now the built-in clock starts working.

To check the current time when the System is turned on

2sec.

SET
/DISPLAY	Clock

Source information

Turning Off the Power Automatically Remote

ONLY

With Sleep Timer, you can fall asleep listening to music.

1Specify the time (in minutes).

SLEEP 10 SLEEP 20 SLEEP 30 SLEEP 60

Canceled SLEEP 150 SLEEP 120 SLEEP 90

SLEEP

2Wait until the set time goes off.

To check the time remaining until the shut-off time

• If you press the button repeatedly, you can change the shut-off time.

•If you have already adjusted the clock before, press the button repeatedly until the clock time starts flashing.

16