JVC MX-JE5, MX-JE31 manual Maintenance, Setup Menu Operations see pages 36 to, Handling discs

Timer Operations (see pages 34 to 35)

Setting the Timer:

•If you do not specify the preset station or track number correctly while setting a timer, the currently selected station or the first track will be played when timer is activated.

•When you unplug the AC power cord or if a power failure occurs, the timer will be canceled. You need to set the clock first, then the timer again.

•Without stopping the recording, you cannot change the source after Recording Timer starts recording.

•If you set DVD Video as the source, Daily Timer will not work correctly.

Timer Priority:

•If you set the Sleep Timer after Daily Timer starts playing the selected source, Daily Timer is canceled.

•If you set the Sleep Timer after Recording Timer starts recording, Recording Timer is canceled, but recording continues until Sleep Timer shuts off the power.

Setup Menu Operations (see pages 36 to 37)

General:

•If the upper and lower parts of the menu are cut off, adjust the picture size control of the TV.

LANGUAGE menu:

•When the language you have selected for MENU LANGUAGE, AUDIO LANGUAGE, or SUBTITLE is not recorded on a disc, the original language is used as the initial language.

PICTURE menu—MONITOR TYPE:

•Even if “4:3 PS (MULTI)” is selected, the screen size may become 4:3 letter box with some DVD Videos. This depends on how the discs are recorded.

•When you select “16:9 (MULTI)” for a picture whose aspect ratio is 4:3, the picture slightly changes due to the process for converting the picture width.

AUDIO menu—DOWN MIX:

•This setting is not effective when DTS multi-channel software is played back.

OTHERS menu—ON SCREEN GUIDE:

•The setup menu and on-screen bar will be displayed (and recorded) even though this function is set to “OFF.” Subtitles and the information for zoom-in always appear on the display regardless of this setting.

Maintenance

To get the best performance of the System, keep your discs, tapes, and mechanism clean.

Handling discs

•Remove the disc from its case by holding it at the edge while pressing the center hole lightly.

•Do not touch the shiny surface of the disc, or bend the disc.

•Put the disc back in its case after use to prevent warping.

•Be careful not to scratch the surface of the disc when placing it back in its case.

•Avoid exposure to direct sunlight, temperature extremes, and moisture.

To clean the disc:

Wipe the disc with a soft cloth in a straight line from center to edge.

Handling cassette tapes

•If the tape is loose in its cassette, take up the slack by inserting a pencil in one of the reels and rotate it.

–If the tape is loose, it may get stretched, cut, or caught in the cassette.

•Be careful not to touch the tape surface.

•Avoid the following places to store the tape—in dusty places, in direct sunlight or heat, in moist areas, on a TV or speaker, or near a magnet.

To keep the best recording and playback sound quality:

•Use a cotton swab moistened with alcohol to clean the heads, capstans, and pinch rollers.

•Use a head demagnetizer (available at electronics and audio shops) to demagnetize the heads (when the System turned off).

Cleaning the System

•Stains should be wiped off with a soft cloth. If the System is heavily stained, wipe it with a cloth soaked in water- diluted neutral detergent and wrung well, then wipe clean with a dry cloth.

•Since the System may deteriorate in quality, become damaged or get its paint peeled off, be careful about the following:

–DO NOT wipe it with a hard cloth.

–DO NOT wipe it strong.

–DO NOT wipe it with thinner or benzine.

–DO NOT apply any volatile substance such as insecticides to it.

–DO NOT allow any rubber or plastic to remain in contact for a long time.

41