JVC MX-K30 manual Connecting the AM Antenna, Connecting the Speakers, Getting Started, Cautions

Models: MX-K30

1 62
Download 62 pages 42.7 Kb
Page 8
Image 8
Getting Started

Getting Started

Connecting the AM Antenna

Rear Panel of the Unit

Turn the loop until you have the best reception.

AM loop antenna (Supplied)

Attach the AM loop to its base by snapping the tabs on the loop into the slot in the base.

AM antenna wire (not supplied)

If reception is poor, connect the outside antenna.

Even when connecting an outside AM antenna, keep the indoor AM loop connected.

Connecting the AM AntennaCAUTION:

To avoid noise, keep antennas away from the System, the connecting cord and the AC power cord.

Connecting the Speakers

1.Open each of the terminals to connect the speaker wire leads.

2.Connect the speaker cords to the Speaker terminals of the Unit.

Connect the red (+) and black (–) cords of the right side speaker to the red (+) and black (–) terminals marked RIGHT on the System. Connect the red (+) and black (–) cords of the left side speaker to the red (+) and black (–) terminals marked LEFT on the System.

3.Close each of the terminals to securely connect the cords.

Right side (rear view)

Left side (rear view)

Red

Black

Black

Red

Rear Panel of the UnitCAUTIONS:

A TV may display irregular colors if located near the speakers. If this happens, set the speakers away from the TV.

Use speakers with the correct impedance only. The correct impedance is indicated on the rear panel.

5

Page 8
Image 8
JVC MX-K30 manual Connecting the AM Antenna, Connecting the Speakers, Getting Started, Rear Panel of the Unit, Cautions