Connecting Other Equipment
You can connect an audio equipment.
•DO NOT connect any equipment while the power is on.
•DO NOT plug in any equipment until all connections are complete.
To connect an analog component
Be sure that the plugs of the audio cords are color coded: White plugs and jacks are for left audio signals, and red ones for right audio signals.
AUX IN
Audio equipment
To audio output
For playing the other equipment through this unit,
connect between the audio output jacks on the other equipment and AUX IN jacks by using audio cords (not supplied).
Adjusting the Voltage Selector
Before plugging in the unit, set the correct voltage for your area with the voltage selector on the rear of the unit.
• DO NOT plug in before setting the voltage selector on the rear of the unit and all connection procedures are complete.
110 | 240 |
| |
127 | - |
| 220 |
VOLTAGE | |
SETTING | |
110 |
|
|
127 | 230 | - |
| 220 |
|
VOLTAGE
SETTING
Using a screw driver, set the voltage selector so that the arrow on printed on the rear points the correct voltage where you use this unit. (See the back cover page.)
English
NOW, you can plug in the unit and other connected equipment FINALLY!
Cancelling the Display Demonstration
When connecting the AC power cord into a wall outlet, the unit automatically starts display demonstration.
On the unit ONLY:
To cancel the display demonstration, press CANCEL
/DEMO
DEMO.
When you press other buttons
The display demonstration stops temporarily. It will start automatically again (if no operation is done for 2 minutes) until you cancel it by pressing DEMO.
To start the display demonstration manually
Press and hold DEMO again for more than | CANCEL |
2 seconds. | /DEMO |
|
– 8 –
