The factory settings vary depending on the model.
The factory settings vary depending on the model.

Preparations and Main Functions

Intercom

Intercommunications between operators are necessary in a system composed of multiple cameras and remote control units.

RM-HP250AU Rear Panel

TALLY

 

INTERCOM

 

AUX VIDEO INPUT

GENLOCK INPUT

PGM PVW C

H

C

G

 

 

AC ` IN AC120V 60Hz

RTS

 

RM-HP250DE Rear Panel

TALLY

 

INTERCOM

 

AUX VIDEO INPUT

GENLOCK INPUT

PGM PVW C

H

C

G

 

 

AC ` IN 230V` 50Hz

Front Panel

INTERCOM LEVEL control

TALLY CALL

FULL AUTO

F1

SHUTTER

2. CABLE

BARS F2

GAIN

INTERCOM

LEVEL

Intercom connector

RM-HP250AU : RTS system. *1

RM-HP250DE : 2-wire system, which uses the H and C terminals. *1

An intercom connector is provided on the front panel of the

RM-HP250.

The volume level of the headset’s earphone can be adjusted using the INTERCOM LEVEL control.

Intercom Input Connector (XLR 5 Pin)

Input connector for intercom headset. (Dynamic only) Recommended headset: DT109 (Beyerdynamic)

1

5

 

Signal

 

 

1

MIC (H)

 

 

2

MIC (C)

2

4

3

EAR (C)

34 EAR (H) – LEFT

(Surface profile)

5 EAR (H) – RIGHT

 

NOTE

●Examples of suitable headsets DT109 (Beyerdynamic)

Headsets from other manufacturers with: Microphone output impedance: 50 W to 200 W Earphone input impedance: 50 W to 400 W

Camera Operator Call

This function makes it possible to call the camera operator without using the intercom. The camera operator is informed of the call by the blinking of the tally lamp on the camera.

TALLY CALL

FULL AUTO

F1

SHUTTER

2. CABLE

BARS F2

GAIN

INTERCOM

LEVEL

CALL button

When the CALL button is pressed, the button light is lit and the tally lamp on the camera blinks. Pressing the button again turns off both the button light and the blinking of the camera’s tally lamp.

NOTE

The tally lamp on the camera does not blink or light when either the camera or the RM-HP250are switched off. When the CALL button of the camera is pressed, the CALL button of RM-HP250 blinks in red.

Tally

The TALLY lamp on the front panel lights when signals are applied to the TALLY terminals on the rear panel.

TALLY

 

INTERCOM

 

AUX VIDEO INPUT

GENLOCK INPUT

PGM PVW C

H

C

G

 

 

C (Common) terminal

PVW (Preview) terminal

PGM (Program) terminal

RM-HP250AU : Contact supply mode *1

RM-HP250DE : Voltage supply mode *1

●TALLY lamp will light up in red when PGM (Program) terminal and C (Common) terminal are in the contact status (RM-HP250AU) or when 2 points of rated voltage are ignited (RM-HP250DE).

●TALLY lamp will light up in green when PWW (Preview) terminal and C (Common) terminal are in the contact status (RM-HP250AU) or when 2 points of rated voltage are ignited (RM-HP250DE).

*1 If tally and intercom settings (for changing model from AU to DE or vice versa) are required, the setting of the internal circuitry should be changed; consult the nearest JVC-authorized service agent.

(The modifications and adjustments will be carried out with charge.)

14