Setting the daily timer
Once the timer has been set, it will be activated at the same time everyday until the timer is turned off. Recording timer works only one time.
•While the timer is being set, the timer indicator ( 
) lights up.
•While the timer has been set, the timer indicator ( 
) also lights up if the power is supplied through the AC outlet.
•While the timer is working, the timer indicator ( 
) blinks.
Using the remote control only
■1. Press 
ON/STANDBY.
■2. Press CLOCK/TIMER.
“TIMER ON?” appears.
•Press SET to activate the timer setting you have made before.
•Press CANCEL to cancel the timer.
•Go to the next step to reset the timer (or set the timer first time).
■3. Press CLOCK/TIMER again, so that the timer indicator ( 
) and ON indicator light up.
The hour digit of the current ON time blinks on the display.
■4. Set the on-time you want the system to turn on.
(1)Press ¢ or 4 to select the hour, then press SET.
(2)Press ¢ or 4 to select the minute, then press SET. The OFF indicator lights up.
•Press and hold the button will change the time rapidly.
•If you want to change the time setting, press
CANCEL.
■5. Set the OFF time (example: 1:30).
(1)Press ¢ or 4 to select the hour, then press SET.
(2)Press ¢ or 4 to select the minute, then press SET.
•Press and hold the button will change the time rapidly.
•If you want to change the time setting, press
CANCEL.
■6. Press ¢ or 4 to select the music source you want to listen to, then press SET.
Each time you press the button, the display changes as shown below:
TUNER = TU\TAPE = CD = TAPE = (back to the beginning)
When you select the “TU\TAPE”;
•The REC indicator appears on the display.
•The timer will be canceled after tuner recording has been finished.
■7. Press ¢ or 4 to select the volume level, then press SET.
–
0 to 50 : When the timer is turned on, the volume will be automatically set to the selected level.
• The current timer setting appears for confirmation.
■8. Before turning off the system, prepare the music source selected in step 6. .
TUNER : Tune into the desired station.
TU\TAPE : The last tuned station will be recorded. Insert a
| cassette tape for recording the station. |
CD | : Set a disc. |
TAPE | : Insert a tape. |
■9. Press 
ON/STANDBY to turn off the system.
•When the timer turns on, the volume level gradually increases from 0 (zero) to the preset level in step 7. .
However, if the volume has been set to “–
To cancel the operation, press CLOCK/TIMER until the display returns to the original one.
To cancel the timer, press CLOCK/TIMER once, then press CANCEL. (“TIMEROFF” appears, only when power is on.)
To reactivate (or confirm) the canceled timer, press CLOCK/TIMER once, then press SET. (The current timer setting appears for confirmation.)
Notes:
•The timer cannot be set if
•The timer does not work if the system is not in the standby mode (the system needs to be in standby mode at least one minute before the
CAUTION: If memory backup batteries are exhausted or not installed, and the AC power cord is disconnected or there is a power failure, time settings will be erased from memory. If this happens, set the current time (clock) and perform the timer setting again.
18
