JVC RX-5052S, RX-5050B manual Right

Do not connect the AC power cord until all other connections have been made.

AM antenna connections Connecting the Speakers and Subwoofer

English

AM

EXT

AM

LOOP

FM 75

COAXIAL

ANTENNA

AM Loop Antenna (supplied)

Snap the tabs on the loop into the slots of the base to assemble the AM loop antenna.

You can connect five speakers (a pair of front speakers, a center speaker, and a pair of surround speakers) and a subwoofer.

CAUTIONS:

•Use only the speakers of the SPEAKER IMPEDANCE indicated by the speaker terminals.

•Do not connect more than one speaker to each speaker terminal.

Connecting the speakers

1 2 3 4

	LEFT	LEFT		LEFT
	+
RIGHT		+	RIGHT	+

– – –

1 2 3

Outdoor single vinyl-covered wire (not supplied)

Turn the loop until you have the best reception.

Notes:

• If the AM loop antenna wire is covered with vinyl, remove the vinyl by twisting it as illustrated.

•Make sure the antenna conductors do not touch any other terminals, connecting cords and power cord. This could cause poor reception.

•If reception is poor, connect an outdoor single vinyl-covered wire (not supplied) to the AM EXT terminal. (Keep the AM loop antenna connected.)

1Twist and remove the insulation at the end of each speaker cord.

2Press and hold the clamp of the speaker terminal.

3Insert the speaker cord.

4Release the finger from the clamp.

For each speaker (except for a subwoofer), connect the (+) and

(–)terminals on the rear panel to the (+) and (–) terminals marked on the speakers.

				:	IMPEDANCE
			CAUTION
			SPEAKER16
			—
			8
		FRONT
	SURROUND	SPEAKERS	+
CENTER			–
SPEAKER

+	To left
–	front speaker
	To left surround
To center speaker	speaker
To right front speaker
To right surround speaker

5