9
English
Basic Operations
The following operations are commonly used when you play any sound sources.
Operations hereafter will be explained using the buttons on the front panel.
You can also use the buttons on the remote control for the same functions if they have the same and similar names/marks.

Selecting the Source to Play

When you have connected digital source components using the
digital terminals, first change the input mode for these components
to the digital input mode (see page 11).

Press one of the source selection buttons.

Note:
When connecting a CD recorder to the TAPE/CDR jacks, change the
source name shown on the display. For details, see page 12.

Daily Operational Procedure

1Turn on the power.

• See “Turning On the Power” below.

2Select the source.

• See “Selecting the Source to Play” to the right.

3Adjust the volume.

• See “Adjusting the Volume” on page 10.

4Select the Surround or DSP modes.

• See “Activating the Surround Modes” (page 25) and
“Activating the DSP Modes” (page 27).

Turning On the Power

Press STANDBY/ON (or STANDBY/ON AUDIO on

the remote control).

The STANDBY lamp goes off.
To turn off the power (into standby mode),
press STANDBY/ON (or STANDBY/ON AUDIO on the
remote control) again.
The STANDBY lamp lights up.
Note:
A small amount of power is consumed in standby mode. To turn off
the power completely, unplug the AC power cord.
On the front panel
On the remote
VOLUME
Current source name appears.
Current volume level appears.
DVD VCR CD FM/AM
TAPE/CDR
TV SOUND
SOURCE NAME
TAPE/CDR CD DVD
FM/AM TV SOUND VCR
Selected source name appears.
VOLUME
09-13_5050&5052[C]1.p65 04.12.8, 1:15 PM9