Activating the Surround Sounds
5. Press Control @/ # to select the center mode.
Each time you press the button, the center modes change as follows:
WIDE
NORMAL 
PHANTOM
WIDE | Select this mode when the center speaker can reproduce the bass |
| better than the front speakers. All signals of the center channel are |
| output through the center speaker. |
|
|
NORMAL | Select this mode when the center speaker cannot reproduce the |
| bass better than the front speakers. The bass portions of the center |
| channel signals are output through the front speakers. |
|
|
PHANTOM | Select this mode when you do not use a center speaker. The center |
| speaker channel signals are output through the front speakers. |
|
|
6. Press Control %/ Þ until
7. Press Control @/ #to adjust the delay time of the rear speaker output.
Each time you press the button, the delay time changes as follows:
DELAY 1
DELAY 2 
DELAY 3 
DELAY 1 | Select this when the distance from you to your rear speakers is | |
| greater than that to the front speakers. | |
|
|
|
DELAY 2 | Select this when the distance from you to your rear speakers is | |
| almost equal to that to the front speakers. | |
|
| |
DELAY 3 | Select this when the distance from you to your rear speakers is less | |
| than that to the front speakers. | |
|
|
|
8. Press Control %/ Þ until “TEST” appears on the display, then press Control @/ # to start checking the speaker output balance.
“TEST” starts flashing on the display, and a test tone comes out of the speakers in the following order:
Left front |
| Center |
| Right front |
speaker |
| speaker |
| speaker |
Rear speakers
Note:
When you have selected “3CHLOGIC,” you cannot select “PHANTOM.”
Note:
When you have selected “3CHLOGIC” or “THEATER,” you cannot adjust the delay time.
Notes:
•No test tone comes out of the rear speakers when you have selected “3CHLOGIC.”
•No test tone comes out of the center speaker when you select “PHANTOM” for the center mode.
29
