JVC RX-554VBK manual Operating Other Components

Operating Other Components

IMPORTANT:

To operate JVC video components using this remote control:

•Aim the remote control directly at the remote sensor on the VCR or TV, not on

Note:

If you choose a source on the front

the receiver.

7After pressing VCR, you can perform the following operations on the VCR:

3Starts playback.

4 Rewinds a video tape. ¢ Fast winds a video tape.

7Stops operation.

8Pauses. To resume playing, press 3.

You can always do the following on the VCR:

•Change the channels on the VCR using the VCR CH +/–button.

•Turn on and off the VCR by pressing VCR in the POWER section.

7You can always perform the following operations on the TV:

•Change the TV’s input mode to either “TV” or “VIDEO” using the TV/VIDEO button.

•Change the TV volume using the TV VOL. +/– button.

•Change the channels on the TV using the TV CH +/–button.

•Turn on and off the TV by pressing TV in the POWER section.

POWER

CD TV VCR AUDIO

TAPE	DAP MODE	3D-PHONIC	SURROUND
	1	2		3
TUNER/	EFFECT	DELAY	TEST
BAND	4	5		6
VCR	SEA MODE	– REAR		+
	7/P	8		9
VIDEO	SEA	– CENTER		+
	PRESET	10	+10
PHONO	SOUND		ONE TOUCH
	CONTROL CD-DISC OPERATION
– TV CH +		– VCR CH +
– TV VOL. +
TV/
VIDEO
	– VOLUME +		MUTING

RM-SR554U REMOTE CONTROL

panel, the remote control will not operate that source.

Notes:

• If you press SOUND CONTROL, you cannot operate the VCR with this remote control. If this happens, press the VCR again, so operating buttons for video components will work for the VCR.

•If you press the VCR (the one of the source selection) on the remote control aiming at the JVC TV, the TV’s input mode will change to the video input.

35