Crossover Frequency Setting
Small speaker cannot reproduce the bass sound very well. So, if you have used a small speaker any for the front, center, or rear channels, this receiver automatically reallocates the bass elements, originally assigned to the channel for which you have connected the small speaker, to another channel (for which you have connected the large speaker).
If you have selected “LARGE” for all speakers (see page 12), this function will not take effect. To use this function properly, you need to set this crossover frequency level according to the size of the small speaker connected.
This function takes effect in the following cases:
-When playing a source using Dolby Pro Logic, Dolby Digital, or DTS Digital Surround.
-When using the DAP modes.
Low Frequency Effect Attenuator Setting
If the bass sound is distorted while playing back a source using Dolby Digital or DTS Digital Surround, follow the procedure below.
•This function takes effect only when the subwoofer (LFE) signals come in (with “SUBWOOFER” set to “Yes”).
On the front panel ONLY:
1. Press SETTING repeatedly until | SETTING |
| |
“LFE ATT” (Low Frequency |
|
Effect Attenuator) appears on the |
|
display. |
|
•Once you have pressed SETTING, MULTI CURSOR %/ Þ can be also used for selecting “LFE ATT.”
•The display changes to show the current setting.
English
On the front panel ONLY:
1. Press SETTING repeatedly until “CROSSOVER FRQ” (Crossover Frequency) appears on the display.
SETTING
2. Press MULTI CURSOR @/ #to | MULTI CURSOR |
select the low frequency effect |
|
attenuator level. |
|
• As you press it, the display changes to show the following:
•Once you have pressed SETTING, MULTI CURSOR %/ Þ can be also used for selecting “CROSSOVER FRQ.”
•The display changes to show the current setting.
MULTI CURSOR
2.Press MULTI CURSOR @/ #to select the crossover frequency level according to the size of the small speaker connected.
• As you press it, the display changes to show the following:
80Hz
100Hz
120Hz
• Use the following comments as reference when adjusting.
80Hz: Select this when the cone speaker unit built in the speaker is about 4 3/4 inches (12 cm).
100Hz: Select this when the cone speaker unit built in the
speaker is about 3 15/16 inches (10 cm).
120Hz: Select this when the cone speaker unit built in the speaker is about 3 3/16 inches (8 cm).
0dB 
10dB
0dB: Normally select this.
10dB: Select this when the bass sound is distorted.
Dynamic Range Compression Setting
You can compress the dynamic range (difference between maximum sound and minimum sound) of the reproduced sound. This is useful when enjoying surround sound at night.
•This function takes effect only when playing back a source using Dolby Digital.
On the front panel ONLY:
1. Press SETTING repeatedly until | SETTING |
“D. RANGE COMP.” (Dynamic |
|
Range Compression) appears on |
|
the display. |
|
•Once you have pressed SETTING, MULTI CURSOR %/ Þ can be also used for selecting “D. RANGE COMP.”
•The display changes to show the current setting.
2. Press MULTI CURSOR @/ #to | MULTI CURSOR |
| |
select the appropriate item about |
|
the compression level. |
|
• As you press it, the display changes to show the following:
OFF 
MID
MAX
OFF: Select this when you want to enjoy surround with its full dynamic range. (No effect applied)
MID: Select this when you want to reduce the dynamic range a little. (Factory setting)
MAX: Select this when you want to apply the compression effect fully. (Useful at night)
13
