JVC RX-6100VBK manual English, Adjust the speaker output levels

4.Adjust the speaker output levels.

•To adjust the center speaker level, press CNTR –/+ (from –10 dB to +10 dB).

•To adjust the left rear speaker level, press REAR•L –/+ (from –10 dB to +10 dB).

•To adjust the right rear speaker level, press REAR•R –/+ (from –10 dB to +10 dB).

CNTR

3 4

REAR•L

5 6

ENTER

REAR•R

JVC Theater Surround adjustments

Before you start, remember...

•Make sure that you have set the speaker information correctly (see page 12).

•There is a time limit in doing the following steps. If the setting is canceled before you finish, start from step 1 again.

•You cannot adjust the rear speaker output levels when you have set “REAR SPK” to “NONE.” See page 12.

•You cannot adjust the center speaker output level and center tone when you have set “CENTER SPK” to “NONE.” See page 12.

English

7/P 8

5. Press TEST again to stop the test	TEST
tone.	0

On the front panel:

You can also use the buttons on the front panel to adjust the Surround modes. However, no test tone is available when using the buttons on the front panel. So, make adjustments while listening to the sound of the source played back.

1. Press SURROUND to activete an	SURROUND
appropriate Surround mode —
PRO LOGIC, DOLBY DIGITAL

From the remote control:

1.Press SURROUND MODE repeatedly until “THEATER” appears on the display.

•The Ù PRO LOGIC and DSP indicators also light up on the display.

2.Press SOUND.

The 10 keys are activated for sound adjustments.

3. Press TEST to check the speaker output balance.

“TEST TONE L” starts flashing on the display, and a test tone comes out of the speakers in the following order:

SURROUND

MODE

SOUND

TEST

0

or DTS SURROUND.

•Each time you press the button, the Surround mode turns on and off alternately.

•When “PRO LOGIC” is selected, the Ù PRO LOGIC indicator lights up on the display.

TEST TONE L		TEST TONE C		TEST TONE R
(Left front speaker)		(Center speaker)		(Right front speaker)
	TEST TONE LS		TEST TONE RS
	(Left rear speaker)		(Right rear speaker)

Notes:

2.Adjust the speaker output levels.

1)Press ADJUST repeatedly until one of the following indications appears on the display.

“CENTER LEVEL”:

To adjust the center speaker level. “REAR L LEVEL”:

To adjust the left rear speaker level. “REAR R LEVEL”:

To adjust the right rear speaker level.

•Once you have pressed ADJUST, MULTI CURSOR %/ Þcan be also used for selecting the speaker.

2)Press MULTI CURSOR @/ # to adjust the selected speaker output level (from –10 dB to +10 dB).

3)Repeat 1) and 2) to adjust the other speaker output levels.

ADJUST

MULTI CURSOR

•You can adjust the speaker output levels without outputting the test tone.

•No test tone comes out of the center speaker when “CENTER SPK” is set to “NONE” (see page 12).

•No test tone comes out of the rear speakers when “REAR SPK” is set to “NONE” (see page 12).

23