JVC RX-DV3SL manual Basic Settings, Operation Buttons, Operating Procedure

English

Basic Settings

Some of the following settings are required after connecting and positioning your speakers while others will make operations easier. You can set the items by using the SETTING button and CONTROL 5/∞/2/3 buttons on the front panel.

Setting items:
•	Speaker information for front, center, rear speakers, and subwoofer*			• Speaker distance for front, center, and rear speakers*
•	Crossover frequency*	•	Low frequency effect attenuator*		•	Dynamic range compression*
•	Digital input (DIGITAL IN) terminals	•	Auto surround		•	Video output mode

Note:

*You can also set these items using the Choice menu (see pages 47 to 52).

Operation Buttons

To do the basic settings for this unit, use the buttons on the front panel.

SETTING

CONTROL

	On the front panel ONLY
Button		To do
SETTING		Display the setting indications on the
		display*.
CONTROL 5/∞		Select an item on the display.
		Each time you press the button, the
		indication changes as illustrated below.
CONTROL 3/2		Adjust the selected item.

•When no operation is done for about 5 seconds, the indications on

the display will disappear.

*Pressing SETTING repeatedly also changes the indication.

Configuration of the indications on the display

SUBWFR	VOUT
(Subwoofer)	(Video out)
FRNT SP	AUTO SR
(Front speaker)	(Auto surround)
CNTR SP	DGT
(Center speaker)	(Digital)
REAR SP	D.COMP
(Rear speaker)	(Dynamic range compression)
FRNT D	LFE
(Front distance)	(Low frequency effect)
CNTR D	CROSS
(Center distance)	(Crossover)
REAR D
(Rear distance)

Operating Procedure

Ex. : When setting the digital input (DIGITAL IN) terminals.

Before you start, remember...

There is a time limit in doing the following steps. If the setting is canceled before you finish, start from step 1 again.

1 Press SETTING.		SETTING
The CONTROL buttons now work for basic settings.
The setting item selected previously appears on the
display.
2 Press CONTROL ∞ (or 5)
repeatedly until “DGT (Digital)”		CONTROL
(with the current setting)* appears
on the display.
DIGITAL AUTO
L R	SPK.	VOLUME

*“1DBS 2TV” is the initial setting. If you have already changed the setting, another combination will be shown.

3 Press CONTROL 3 (or 2) to select

the appropriate digital terminal	CONTROL
setting.

•Each time you press the button, the indication changes as follows:

DIGITAL AUTO
L	R	SPK.
		VOLUME

DGT1DBS 2TV DGT1DBS2CDR

DGT1TV 2DBS DGT1TV 2CDR

DGT1CDR2DBS DGT1CDR 2TV

(back to the beginning)

19