JVC SR-VS20U manual Recording Features

36EN

PLAYBACKANDRECORDINGFEATURES(cont.)

Recording Features

	MONITOR
.
A

DISPLAY

T	2	W
1		3
		2
4	5	6
7	8	9
C.RESET	0	4

Display Elapsed Recording

Time (VHS deck only)

1	RESET COUNTER TO ZERO
	Before recording starts, press C.RESET. The counter
	resets to zero and displays the exact elapsed time as the
	tape runs.

	DISPLAY ELAPSED TIME ON
2	SCREEN
	During recording, press DISPLAY at any time to see the
	elapsed time.
	All indications corresponding to the current status of the
	VCR are displayed for 5 seconds. The counter display
	remains on the screen indicating the elapsed time.
	Press DISPLAY again to remove the display.
	● Make sure "SUPERIMPOSE" is set to "ON" (☞ pg. 27).
	● The indications are not recorded.
	● Press DISPLAY to change to the COUNT display if
	"REMAIN" is displayed.

LAY
1	DV S-VHS

FF

REW

PAUSE

3

MENU

OK

Record One Program While Watching Another

1	ENGAGE TV MODE
	During recording...
	● Change the TV's input mode from AV to TV.
	SELECT CHANNEL FOR
2	VIEWING
	Use the TV’s channel selector to set the channel you
	want to watch.

Display Tape Remaining Time

(VHS deck only)

DISPLAY COUNTER

INFORMATION

1 Press DISPLAY.

All indications corresponding to the VCR's current status are displayed for 5 seconds. The counter display remains on the screen indicating the elapsed time.

DISPLAY TAPE REMAINING TIME

2 Press DISPLAY repeatedly until "REMAIN" appears on screen. The approximate tape remaining time appears on the TV screen and also on the VCR display panel with a "" indicator.

●The tape remaining time is calculated based on the tape speed (SP or EP) being used. The indicated remaining time is only an estimate.

●Press DISPLAY to change the on-screen display from "REMAIN" to "COUNT" and vice versa; and to show counter reading, channel number, clock time or tape remaining time on the front display panel. Then channel number will not be displayed when the VCR is playing a tape.

EXIT THE DISPLAY

3 Press DISPLAY again.

NOTES:

●"SUPERIMPOSE" must be set to "ON", or the on-screen display will not appear (☞ pg. 27).

●Near the beginning of the tape, the tape remaining estimate may be inaccurate. However, the estimate becomes more accurate as the tape comes closer to the end.

●Depending on the type of tape used, the tape remaining time reading may not appear right away, or may not be correct. "- -:- -" may sometimes appear, or the display may blink on occasion.

●The tape remaining time indication is not accurate when using VHS-C tapes with VHS-C adapter.