Recording
Tape recording (Basic operation)
Three tape types including normal (Type I), High position (Type II) and Metal (Type IV) tapes can be recorded onto. The type of tape is identified automatically by the cassette deck.
1Load the tape for use in recording, with the
side A facing up.
Press 0 to open the tape tray, place a tape on it and press 0 to close it.
•It is not possible to record onto a cassette tape with the broken accidental erasure tab. Use a cassette the tab of which is not broken.
2Prepare the recording source (Tuner, CD or MD, etc.).
•To record radio broadcast, receive a station with the tuner.
•To record CDs, load the desired CDs and program tracks if required.
•To record an MD, load the desired MD and program tracks if required.
•To record a component connected to AUX, prepare it as required.
*Refer to the instruction manual of the source component for its operating procedure.
REC PAUSE CD REC
3Select the recording source with the amplifier’s input selector.
4Press REC PAUSE.
The REC indicator lights in red to indicate
5Start playing the source component.
If you want to record CD or MD tracks from the first track, first perform step 6 below (i.e. start recording) then start playing the source.
6Press Û or Ü.
•Pressing Ü starts recoding on side A (top side).
•Pressing Û starts recoding on side B (bottom side). The tape indicator starts blinking to indicate that the recording is under way.
•The recording level is set automatically.
•Press 7 to stop recording.
•Press 0 to eject the tape.
12
