Operating external components with the remote control

The buttons described below are used on pages 12 and 13.

Number buttons

Remote control mode selector

(play button)

NOTE

•Manufacturers’ codes are subject to change without notice.

•Set the codes again after replacing the batteries of the remote control.

Operating the TV

7To set the manufacturer’s code
1 Slide the remote control mode selector to TV.
2 Press and hold F TV.

Keep the button pressed until step 4 is finished.

3 Press ENTER.
4 Press number buttons (1-9, 0) to enter the manufacturer’s code (2 digits).
Examples:

For a Hitachi TV: Press 1, then 0.

For a Toshiba TV: Press 0, then 8.

Manufacturer

Code

Manufacturer

Code

 

 

 

 

JVC

01*

Samsung

12

 

 

 

 

Hitachi

10

Sanyo

13, 14

 

 

 

 

Magnavox

02

Sharp

06

 

 

 

 

Mitsubishi

03

Sony

07

 

 

 

 

Panasonic

04, 11

Toshiba

08

 

 

 

 

Philips

15

Zenith

09

 

 

 

 

RCA

05

 

 

 

 

 

 

*“01” is the initial setting.

5 Release F TV.

If there is more than one code listed for corresponding brand, try each one until you enter the correct one.

7Operation

Aim the remote control at the TV.

IMPORTANT

Before using the remote control to operate a TV;

• Set the remote control mode selector to TV.

The following buttons are available:

FTV:Turns TV on and off.

TV VOL +/–:

Adjusts the volume.

TV/VIDEO:

Selects the input mode (either TV or

 

VIDEO).

CH +/–:

Changes the channels.

1-10, 0, h10 (100+):

Selects the channel.

TV RETURN:

Alternates between the previously selected

 

channel and the current channel.

NOTE

• The operating buttons may differ depending on manufacturers.

Operating the DBS tuner or CATV converter

7To set the manufacturer’s code

1 Slide the remote control mode selector to VCR/DBS.
2 Press DBS.
3 Press and hold F VCR/DBS.

Keep the button pressed until step 5 is finished.

4 Press ENTER.

Continued on the next page

12