References
Maintenance
7Handling Discs• Remove the disc from its case by holding it at the edge while pressing the center hole lightly.
• Do not touch the shiny surface of the disc or bend the disc.
• Put the disc back in its case after use to prevent warping.
• Be careful not to scratch the surface of the disc when placing it back in its case.
• Avoid exposure to direct sunlight, temperature extremes and moisture.
Wipe the disc with a soft cloth in a straight line from center to edge.
•DO NOT use any solvent — such as conventional record cleaner, spray, thinner or benzine — to clean the disc.
7Cleaning the system•Stains on the system should be wiped off with a soft cloth. If the system is heavily stained, wipe it with a cloth soaked in water- diluted neutral detergent and wrung well, then wipe clean with a dry cloth.
•Since the system may deteriorate in quality, become damaged or get its paint peeled off, be careful about the following.
for a long time.
Troubleshooting
PROBLEM | POSSIBLE CAUSE | SOLUTION | |
|
|
| |
Power does not come on. | The power cord and/or system cord is not connected. | Connect the power cord and system cord correctly. (See | |
|
| pages 10 and 11.) | |
The remote control does | The batteries are exhausted. | Replace the batteries. (See page 7.) | |
not work. |
|
| |
Sunlight is shining directly on the remote sensor. | Hide the remote sensor from direct sunlight. | ||
| |||
No sound. | The system cord and/or speaker cord is not connected. | Check the connection. | |
| The audio cord is not connected to AUX IN (VCR) and/ | Connect the cord correctly. (See page 11.) | |
| or DIGITAL IN (DBS) correctly. |
| |
| An incorrect source has been selected. | Select the correct source. (See page 15.) | |
|
|
| |
No picture is displayed | The video cord is not connected correctly. | Connect the cord correctly. (See page 10.) | |
on the TV screen. |
|
| |
The disc or file is not playable. | Use a playable disc or file. (See pages 3 and 4.) | ||
| |||
No picture is displayed | The scan mode is set to “480p” though the center unit is | Change the scan mode to “480i”. (See page 16.) | |
on the TV screen, the | connected to the TV which does not support the |
| |
picture is blurred, or the | progressive video input such as a conventional TV. |
| |
picture is divided into |
|
| |
two parts. |
|
| |
Video and audio are | The disc is scratched or dirty. | Replace or clean the disc. | |
distorted. |
|
| |
A VCR is connected between the center unit and the | Connect the center unit and TV directly. (See page 10.) | ||
| |||
| TV. |
| |
|
|
| |
The picture does not fit | The monitor type is not set correctly. | Set “MONITOR TYPE” properly. (See page 34.) | |
the TV screen. |
|
| |
Hard to listen to | Antennas are disconnected. | Reconnect the antennas correctly and securely. (See | |
broadcast because of |
| page 8.) | |
noise. |
|
|
38