Speaker layout

Connections

Do not connect the power cord until all other connections have been made.

Speaker layout

 

Center speaker

Front left

 

 

Front right

 

 

speaker

 

 

speaker

Powered subwoofer

Surround left

Surround right

speaker

speaker

Place the satellite speakers on a flat and level surface.

The front and center speakers are magnetically shielded to avoid color distortions on TVs. However, if not installed properly, they may cause color distortions. So, pay attention to the following when installing the speakers.

When placing the speakers near a TV set, turn off the TV’s main power switch or unplug it before installing the speakers. Then wait at least 30 minutes before turning on the TV’s main power switch again.

Some TVs may still be affected even though you have followed the above. If this happens, move the speakers away from the TV.

The surround speakers are not magnetically shielded.

If it is located nearby the TV or monitor, it will probably cause color distortion on the screen. To avoid this, do not place the speaker nearby the TV or monitor.

Be sure to place the powered subwoofer to the TV’s right. If you place the powered subwoofer to the TV’s left, keep sufficient distance between them to prevent the TV screen from appearing mottled.

Connecting a TV

You can get better picture quality in the order — Component video > S-video > Composite video.

Distortion of picture may occur when connecting to the TV via a VCR, or to a TV with a built-in VCR.

You need to set “MONITOR TYPE” in the PICTURE menu correctly according to the aspect ratio of your TV. (A pg. 37)

7To connect a TV equipped with the component video input jacks

Center unit

TV

To component video input

Component video cord (not supplied)

NOTE

If your TV supports progressive video input, you can enjoy a high

quality picture by setting the progressive scan mode to active. (A pg. 18)

If the component video input jacks of your TV are of the BNC type, use a plug adapter (not supplied) to convert the pin plugs to BNC plugs.

The component video signals can be output only when you select “DVD” as the source to play. (A pg. 17)

7To connect a TV equipped with the composite or S- video jacks

Center unit

Composite video cord (supplied)

or

 

S-video cord

 

(not supplied)

 

Align the 5 marks.

 

To S-video input

To composite

 

video input

 

TV

12

Page 15
Image 15
JVC TH-C6, TH-C7 manual Speaker layout, Connecting a TV