JVC TH-M42 For TV operations, For DBS tuner or CATV converter operations, Release F TV, F Tv

Getting started

4 Press number buttons (1-9, 0) to enter

	the manufacturer’s code (2 digits).
	Examples:
Remote control	For a Hitachi TV: Press 1, then 0.
	For a Toshiba TV:Press 0, then 8.
mode selector
	Manufacturer	Code	Manufacturer	Code
	JVC	01	Samsung	12
	Hitachi	10	Sanyo	13
	Magnavox	02	Sharp	06
(play button)	Mitsubishi	03	Sony	07
	Panasonic	04, 11	Toshiba	08
	RCA	05	Zenith	09
	5 Release F TV.
	6 Try operating your TV by pressing
	F TV.

Number buttons

When your TV turns on or off, you have entered the correct code.

If there is more than one code listed for corresponding brand, try each one until you enter the correct one.

NOTE

•Manufacturers’ codes are subject to change without notice. If they are changed, this remote control cannot operate the equipment.

•Set the codes again after replacing the batteries of the remote control.

For TV operations

You can operate your TV using the remote control supplied with this system.

• Refer also to the instruction manuals supplied with your TV.

7To set the manufacturer’s code

7Operation

IMPORTANT

Before using the remote control to operate a TV;

• Set the remote control mode selector to TV.

The following buttons are available:

FTV:Turns TV on and off.

TV VOL +/–:	Adjusts the volume.
TV/VIDEO:	Selects the input mode (either TV or
	VIDEO).
CHANNEL +/–:	Changes the channels.
1-10, 0, +10 (100+): Selects the channel.
TV RETURN:	Alternates between the previously selected
	channel and the current channel.

For DBS tuner or CATV converter operations

You can operate a JVC TV without setting the remote control signal.

1 Slide the remote control mode selector to TV.

2 Press and hold F TV.

Keep the button pressed until step 4 is finished.

3 Press ENTER.

You can operate your DBS tuner or CATV converter using the remote control supplied with this system.

•Refer also to the instruction manuals supplied with your DBS tuner or CATV converter.

7To set the manufacturer’s code

1 Slide the remote control mode selector to VCR/DBS.

2 Press and hold DBS.

Keep the button pressed until step 4 is finished.

3 Press ENTER.

15