Quick Setup 2
Step Two - Making Basic Connections
Next you will need to connect your television to an antenna or cable system. The most basic antenna/cable connection is shown below. For more detailed connections, such as ones where a cable box is required, see pages 11 and 12.
Quick Setup 3
Step Three - Auto Tuner Setup
JVC’s onscreen menu system lets you set your television up to meet your own personal viewing preferences. The menu screens and their features are discussed in detail in this book. The menu settings are optional, you can set as many or as few of them as you wish. But to begin watching your television right away you will need to run the Auto Tuner Setup. This lets your television learn the channels it is able to receive. To run the Auto Tuner Setup follow the steps below.
Press the MENU button on the remote control.
INPUT
OVER 
VIDEO | AUDIO OUT |
L/ MONO | L |
R | R |
75Ω
(VHF/UHF)
Cable/RF connector
Illustration of
Press the ❷ buttons to move to AUTO TUNER SETUP
Press the ➛❿ buttons to begin AUTO TUNER SETUP
TUNER MODE | : | CABLE AIR |
START
➛❿ To choose CABLE (if you are connected to a cable system) or AIR (if you use an antenna) ❷ To move to START
1) Connect an RF cable out from the wall outlet in to the RF Input on the back of the TV.
You may also wish to connect a VCR at this point. A basic stereo VCR connection is shown below. For detailed instructions on connecting other components or a home theater system, see pages 11 to 14.
Note: A VCR is not required to operate your television.All others use connections shown on pages 11 and 12.
AV Cables/Plugs
| IN |
| |
BNC |
|
| |
Connector | OUT | Video | |
box | |||
|
|
|
| VCR | |
| IN | Yellow | |
L/ MONO | L | ||
White | |||
|
| ||
|
| Red | |
R |
| IN | |
| Audio |
|
Illustration of
1)Connect the yellow video cable out from the VCR’s Video Output, in to the BNC connector box Input jack, OR connect an
2)Connect the white audio cable out from the VCR’s Left Audio Output, in to the TV’s Left Audio Input Jack.
3)Connect the red audio cable out from the VCR’s Right Audio Output, in to the TV’s Right Audio Input jack.
Finally, once you have finished your connections, plug the power cord into the nearest power outlet and turn on the television.
Proceed to Step Three
8
5
➛❿ To start Auto Tuner Setup
The Auto Tuner will now memorize all of the clear, active channels your television can receive. This will take one or two minutes.
NOW
PROGRAMMING!
48 |
The Auto Tuner is finished when the message PROGRAMMING OVER! appears onscreen.
The Auto Tuner programming is now complete. You can now begin watching your television, or you can continue on in this guide for more information on connecting audio/video devices, programming your remote control, or using the JVC onscreen menu system to customize your television viewing experience.
The Quick Setup
STOP is complete
9
|
