JVC TM-H150CG Input Card option, Component/RGB Input Card IF-C01COMG, SDI Input Card IF-C01SDG

Input Card (option)

7Component/RGB Input Card (IF-C01COMG)

G / Y

INOUT

B/PB/B-Y

INOUT

R/PR/R-Y

INOUT

HD/CS

INOUT

VD

INOUT

AUDIO

IN OUT

1

2

3

4

1Component/RGB signal input/output terminals

Input (IN) and output (OUT) terminals for the component (color difference) or the RGB signal.

To select Component signal: Press the INPUT SELECT C button.

To select RGB signal: Press the INPUT SELECT D button.

•The IN and OUT terminals are bridge-connected (auto termination).

2Connection terminal

Attach to the connection terminal of the input card slot on the monitor.

3Synchronized signal input/output terminals

Input (IN) and output (OUT) terminals for the vertical, horizontal or complex synchronized signals.

• The IN and OUT terminals are bridge-connected (auto termination).

NOTE:

These terminals are available only to the RGB input.

7Acceptable signal formats when installed on this monitor:

525/60i, 625/50i

•G on SYNC cannot be used with the RGB input.

4Audio signal input/output terminals

Input (IN) and output (OUT) terminals for the analog audio signals.

• The IN and OUT terminals are bridge-connected.

NOTE:

You cannot connect both the component signal outputs and the RGB signal outputs at a time.

ENGLISH

7SDI Input Card (IF-C01SDG)

	SWITCHED
	OUT
IN	SDI 1
IN	SDI 2

AUDIO1

IN OUT

AUDIO2

1

2

3

4

1SWITCHED OUT terminal

Output (OUT) terminal for the re-clocked signal. The input signal from the input terminal currently selected (SDI 1 or SDI 2) is re-clocked and output from this terminal.

NOTES:

•No signal is output from the SWITCHED OUT terminal when the main power is turned off.

•Even when the input signal is switched from the SDI Input Card, the SWITCHED OUT terminal still outputs the SDI 1 or SDI 2 re-clocked signal which is selected last time. The re-clocked signal from SDI 1 is output from the SWITCHED OUT terminal when the monitor is in stand-by mode.

2D1 SDI signal input terminal (SDI 1, SDI 2)

Accepts the SMPTE259M D1 SDI signal. The audio signal of the EMBEDDED AUDIO signal cannot be decoded (only the video signal can be decoded).

To select SDI 1: Press the INPUT SELECT C button.

To select SDI 2: Press the INPUT SELECT D button.

7 Acceptable signal formats when installed	3 Connection terminal
on this monitor:	Attach to the connection terminal of the input card slot on the
525/60i, 625/50i	monitor.
	4 Audio signal input/output terminals (for both SDI 1 and
	SDI 2)
	Input (IN) and output (OUT) terminals for the analog audio signals.
	• The IN and OUT terminals are bridge-connected.

7