MENU CONTENTS
You can adjust (set) the following items on the menu screen. Each adjusted (set) value is automatically memorized.
The values inside [ ] are the factory presets.
1CONTRAST (Picture Contrast)
Adjusts the picture contrast. Decreasing the value lowers the contrast, and increasing the value raises it.
Adjustable range: | [0] |
2BRIGHTNESS (Picture Brightness) Adjusts the picture brightness.
Decreasing the value makes the picture darker, and increasing the value makes it brighter.
Adjustable range: | [0] |
3SHARPNESS (Picture Sharpness) Adjusts the picture sharpness.
Decreasing the value makes the picture softer, and increasing the value makes it more sharp.
Adjustable range: | [0] |
4CHROMA (Picture Chroma) Adjusts the picture chroma.
Decreasing the value makes the picture lighter, and increasing the value makes it deeper.
Adjustable range: | [0] |
5PHASE (Picture Phase) Adjusts the picture phase.
Decreasing the value makes the picture more reddish, and increasing the value makes it more
greenish. |
|
Adjustable range: | [0] |
*PHASE can be adjusted only with NTSC video signals.
*PHASE is not displayed when PAL is selected.
6COLOR SYSTEM (Color System)
Displays the color system (NTSC or PAL) used by the video equipment.
*COLOR SYSTEM is not displayed when TV is selected.
7POWER SAVE (Power Save)
With the power save function set to ON (active), the monitor automatically enters standby mode when no video signal is input. When the power save function is active, the POWER indicator blinks in green. When a video signal is input, the power save function becomes inactive and the monitor is restored to normal operation. Pressing any buttons on the front operation panel also sets the power save function to
inactive.[OFF]
*The power save function becomes active when no video signal is input for over 30 seconds.
8COLOR SW
Turns the picture into black and white for
checking the white balance. | [ON] |
The following items are displayed only when TV is selected:
9CH STATUS (Channel Status)
With CH STATUS set to OFF (inactive), the TV channel is not displayed when it is selected.
[ON]
0CH SEARCH START (Initiate Channel Search) The monitor automatically searches for broadcast stations (VHF/UHF) it can receive and memorizes them.
(Also refer to SETTING TV CHANNELS on page 17.)
*The monitor memorizes channels in ascending order.
*When you move the monitor into an area that receives different channels, perform CH SEARCH START again.
!CH SKIP ON (Channel Skip ON)
Deletes a channel set in CH SEARCH 0. Select the channel to be deleted and perform CH SKIP ON.
@CH RESET ON (Channel Reset ON)
Resets all TV channels set in 0 CH SEARCH START to their factory presets. After performing channel reset, all TV channels (VHF: 2 – 13 / UHF: 14 – 69) can be tuned.
15 
