English
Installation procedure
1. Check the strength of the installation location.
The
While referring to the
Units : inches
19/32
51/64
1919/64 1723/32
51/64
365/8
1723/32 | 1723/32 | 19/32 |
131/32 | 315/16 |
|
131/32 |
| |
11/4 |
|
|
Used for routing wires behind a wall | Wall installation holes (6 locations) |
N o t e
Note
• The
If the wall material will not allow sufficient strength to be obtained from using six installation holes, use some of the spare holes. However, depending on the construction material used at the place of installation, cracks may develop if the screws are inserted too close to each other.
2.Install the wall-hanging bracket to the wall.
•Install the
•If it is necessary to embed bolts or nuts beforehand because the wall is made from concrete, use the bracket itself to determine the correct installation hole positions, or use the dimension diagram to calculate the hole positions. Then embed the M6 bolts or nuts into the holes. Furthermore, when embedding the bolts, allow the bolts to protrude from the wall by 13/32 inches to 19/32 inches.
Installation procedure
First screw a bolt into the centre- top hole.
Use a level gauge to correct the alignment of the
N o t e
Note
• Use
10