JVC UX-EP25 Playing Back from the PC, How to install the USB drivers, To play back sounds on the PC, Resume Play for MP3/WMA, To activate/cancel resume play

Resume Play for MP3/WMA

If you press 7while playing MP3/WMA, the number of the track where you have stopped playback will be memorized by the unit.

By pressing CD 6or USB MEMORY 6, you can start playback again from the beginning of the same track.

To activate/cancel resume play	ONLY
	Remote

RESUME ON

RESUME OFF

memo

•Pressing OPEN/CLOSE (for Disc), or disconnecting the USB mass storage class device will erase the track number for resume play.

•To play back from the ﬁrst track while resume play is activated, press 7 twice during playback.

Playing Back from the PC

This System is equipped with a USB terminal on the rear panel.You can connect your PC to this terminal and enjoy the sound out of your PC. When you connect your PC for the ﬁrst time, follow the procedure below.

•Remember you cannot send any signal or data to your PC from this System.

✎IMPORTANT

•Always set volume to “VOLUME MIN” when connecting or disconnecting the other equipment.

How to install the USB drivers

1 Turn on your PC and start running Windows ® 98SE, Windows® Me, Windows® 2000, or Windows® XP.

•If the PC has been turned on, quit all the ap- plications running.

2 Select USB AUDIO for the source.

FM AM

USB AUDIO AUX

3 Connect the System to the PC using a USB cable (not supplied).

(rear panel)	PC
USB cable

•Use “USB series A plug to B plug” cable.

4 The USB drivers are installed automati- cally.

To play back sounds on the PC

Refer to the manuals supplied with the sound reproducing application installed in the PC.

*Microsoft®, Windows® 98SE, Windows® Me, Windows® 2000 and Windows® XP are registered trademarks of Microsoft corporation.

memo

•DO NOT turn off the unit or disconnect the USB cable while installing the drivers and for several seconds while your PC is recognizing the receiver.

•Use a full speed USB cable (version 1.1). Recommended cord length is shorter than approximately 2 m.

•If your PC does not recognize the unit, disconnect the USB cable and connect it again. If it does not work yet, restart Windows.

•The installed drivers can be recognized only when the USB cable is connected between the unit and your PC.

•The sound may not be played back correctly— interrupted or degraded—due to your PC settings and PC speciﬁcations.