Introduction
Thank you for purchasing the JVC Micro |
|
|
|
|
|
| |
|
| Internal heat | |
Component System. |
|
| |
We hope it will be a valued addition to your |
|
|
|
| • | A cooling fan is mounted on the right side | |
home, giving you years of enjoyment. |
| ||
|
| of the unit to prevent heat buildup inside the | |
Be sure to read this instruction manual carefully |
|
| |
|
| ||
before operating your new stereo system. |
|
| |
|
|
| |
In it you will find all the information you need to |
|
|
|
|
| For safety, observe the following carefully: | |
set up and use the system. |
|
| |
|
| • Make sure there is good ventilation the | |
If you have a query that is not answered by the |
|
| |
|
| main unit. Poor ventilation could overheat | |
manual, please contact your dealer. |
|
| |
|
| and damage the System. | |
|
|
| |
Precautions |
|
| • DO NOT block the cooling fan and the |
|
| ventilation openings or holes. If they are | |
|
|
| blocked by a newspaper or cloth, etc., |
|
|
| the heat may not be able to get out. |
|
|
|
Installation
•Install in a place which is level, dry and neither too hot nor too
•Install the System in a location with adequate ventilation to prevent internal heat buildup inside the System.
DO NOT install the System in a location near heat sources, or in a place subject to direct sunlight, excessive dust or vibration.
•Leave sufficient distance between the System and theTV.
•Keep the speakers away from theTV to avoid interference withTV.
Power sources
•When unplugging the System from the wall outlet, always pull on the plug, not the AC power cord.
DO NOT handle the AC power cord with wet hands.
Moisture condensation
Moisture may condense on the lenses inside the
System in the following cases:
•After starting to heat the room
•In a damp room
•If the System is brought directly from a cold to a warm place
Should this occur, the System may malfunction. In this case, leave the System turned on for a few hours until the moisture evaporates, unplug the AC power cord, then plug it in again.
2