To remove the speaker grilles

Troubleshooting

If you are having a problem with your System, check this list for a possible solution before calling for service.

General:

Adjustments or settings are suddenly canceled before you finish.

@There is a time limit. Repeat the procedure again.

Operations are disabled.

@The built-in microprocessor may malfunction due to external electrical interference. Unplug the AC power cord and then plug it back in.

Unable to operate the System from the remote control.

@The path between the remote control and the remote sensor on the System is blocked.

@Point it at the remote sensor on the font panel. @Signals cannot reach the remote sensor.

More closer to the System.

@The batteries are exhausted.

No sound is heard from the speakers.

@Speaker connections are incorrect or loose (see page 7).

@Headphones are connected (see page 9).

Sound from PC connected with a USB cable has some noise. (See page 15)

@PC is subjected to excessive load due to using other applications. Close the applications you do not use.

@PC is connected via USB Hub. Connect the PC directly to the main unit with a USB cable.

Radio Operations:

Hard to listen to broadcasts because of noise (see pages 4 to 7).

@Antennas connections are incorrect or loose. @The AM loop antenna is too close to the

System.

@The FM antenna is not properly extended and positioned.

Disc/iPod/USB mass storage class device

Operations:

The disc does not play.

@The disc is placed upside down. Place the disc with the label side up.

MP3/WMA tracks do not play.

@Track names have the initial letter “.”.

The disc sound is discontinuous.

@The disc is scratched or dirty.

The disc cover does not open or close.

@The AC power cord is not plugged in.

The iPod doesn’t playback although the display indicates CONNECT.

@The battery is empty. Let stand for more than approximately ten minutes on the connecting condition.

Timer Operations:

Daily Timer does not work.

@The System has been turned on when the on- time comes.

Timer starts working only when the System is turned off.

@There might have been a power failure. Set the clock first, then the timer again.

26