JVC UX-GD6M, UX-GD6S !Digital audio component, ⁄To connect the powered subwoofer, @Speakers, Preparingthe remote control, Before plugging in the System

!Digital audio component

PCM	/STREAM	Protective cap
	OPTICAL
DVD
	OUT
DIGITAL

•Set “DIGITAL AUDIO OUTPUT” in the “AUDIO” menu correctly according to the connected digital audio equipment (see page 35). If setting is incorrect, loud noise may be generated causing damage to the speakers.

⁄To connect the powered subwoofer

From the powered	SUB-
	WOOFER
subwoofer	OUT
(not supplied)

@Speakers

•When connecting the speaker cords, match the polarity of the speaker terminals: red color to (+) and black color to (–).

	Red
From right	Black	From left
speaker
		speaker

•DO NOT connect more than one speaker to each terminal.

•DO NOT push or pull the speakers as this will damage the foot spacers at the bottom of the speakers.

When connecting auxiliary equipment (AUX)Stereo mini plug

(not supplied)

Before plugging in the System

Set the correct voltage for your area with the voltage selector on the rear.

Use a screwdriver to set the voltage selector to the same voltage as where you are plugging in the unit. (See also the back cover page.)

VOLTAGE

SELECTOR

110V

127V

220V-

230V

Preparing the remote control

R6(SUM-3)/AA(15F)

•Dispose of batteries in the proper manner, according to federal, state, and local regulations.

DO NOT recharge, short, disassemble or heat the battery or dispose of it in a fire.

When using the remote control

Point the top of the remote control toward the remote sensor as directly as possible. If you operate it from a diagonal position, the operating range (approx. 5 m) may be shorter.

5