JVC UX-P55 manual Connecting Speakers, Release the finger from the clamp, AM MW/LW antenna

AM (MW/LW) antenna

]]

ANTENNA

Connecting Speakers

1	2
	3

1

Vinyl-covered wire (not supplied)

AM EXT

AM LOOP

FM 75

COAXIAL

	Red
RIGHT	LEFT
	MAIN
Speaker	SPEAKERS
	Speaker
cord	cord
SPEAKER
IMPEDANCE
MIN 6
	Black

2

AM loop antenna (supplied)

1Connect the AM loop antenna to the AM LOOP terminals as illustrated.

2Turn the AM loop antenna until you have the best reception.

To connect an outdoor AM (MW/LW) antenna

When reception is poor, connect a single vinyl-covered wire to the AM EXT terminal and extend it horizontally. (The AM loop antenna must remain connected.)

For better reception of both FM and AM (MW/LW)

•Make sure the antenna conductors do not touch any other terminals and connecting cords.

•Keep the antennas away from metallic parts of the unit, connecting cords, and the AC power cord.

Right	Left
speaker	speaker

1Press and hold the clamp of the speaker terminal on the rear of the unit.

2Insert the end of the speaker cord into the

terminal.

Match the polarity of the speaker terminals: Red (+) to red

(+) and black (–) to black (–).

• If the cords are covered with insulation, remove a short section of insulation at the

end of each cord by twisting and pulling it off.

3Release the finger from the clamp.

•DO NOT connect speakers while the power is on.

• DO NOT connect more than one speaker to each speaker teminal.

IMPORTANT: Use only speakers with the same speaker impedance as indicated by the speaker terminals on the rear of the unit.

– 7 –