JVC UX-S57 manual Basic and Common Operations, Setting the Clock, On the remote control only

Basic and Common Operations

Setting the Clock

Before operating the unit any further, first set the unit’s clock.

To show the clock when the unit is turned on

On the remote control ONLY:

When you plug in the power cord, “0:00” starts flashing on

Press DISPLAY.

DISPLAY

the display.

You can set the clock when the unit is either turned on or in standby mode.

The clock indication appears on the display.

To return to the normal display, press DISPLAY

again.

On the remote control ONLY:

1 Press CLOCK/TIMER.

The hour digits start flashing on the display.

2 Press DISC UP or DISC DOWN to adjust the hour, then press CLOCK/TIMER.

The minute digits start flashing.

•When you press and hold DISC UP

or DISC DOWN, the hour digit changes continuously.

CLOCK/

TIMER

DISC UP

DISC DOWN

CLOCK/

TIMER

When playing an MP3 disc

Pressing DISPLAY shows the elapsed playing time instead of the clock time.

To change the clock

1	Make sure the (timer) indicator and the timer mode
	indicator (DAILY) are not lit on the display.
	• If they are lit, press and hold CLOCK/TIMER until they
	go off.
2	Press CLOCK/TIMER repeatedly until the unit enters
	the clock setting mode (the hour digits start flashing
	on the display).
	First time you press CLOCK/TIMER, the unit enters the
	timer setting mode. (See page 22.)
3	Repeat steps 2 and 3 of the procedure “Setting the
	Clock.”

3 Press DISC UP or DISC DOWN to adjust the minute, then press

CLOCK/TIMER.

The built-in clock starts.

4 Press and hold CLOCK/TIMER again so that the

(timer) indicator and the timer mode indicator

(DAILY) go off.

To turn off the clock indication (power save mode)

•When you unplug the power cord or if a power failure occurs The clock is reset to “0:00” right away. If this happens, set the clock again.

•The clock may gain or lose 1 to 2 minutes per month If this happens, reset the clock.

On the remote control ONLY:

Press DISPLAY while the unit is in standby mode. DISPLAY “DISPLAY OFF” appears on the display and the

clock indication goes off.

To turn on the clock indication, press DISPLAY again

while the unit is in standby mode. “DISPLAY ON” appears on the display.

9