JVC UX-V30R, UX-V330R manual Connecting the Speakers, Connecting External Equipment

English

CAUTION: Make all connections before plugging the System into an AC power outlet.

Connecting the Speakers

For each speaker, connect one end of the speaker wire to the speaker terminals on the back of the System.

1.Open each of the terminals and insert the speaker wires firmly, then close the terminals.

2.Connect the red (+) and black (–) wires of the right side speaker to the red (+) and black (–) terminals marked R on the System. Connect the red (+) and black (–) wires of the left side speaker to the red (+) and black (–) terminals marked L on the System.

Right speaker (rear side) Black Left speaker (rear side)

L

R

SPEAKERS

IMPEDANCE

MIN 4Ω

CAUTION:

If a TV is installed near the speakers, the picture on the TV may be distorted. If this happens, set the speakers away from the TV.

Connecting External Equipment

Connect signal cords (not supplied) between the System’s LINE IN (AUX)/LINE OUT terminals and the output/input terminals of an external MD recorder, cassette deck, etc.

You can then listen to the external source through the System, or record the System’s CD player, cassette tape, or tuner to the external unit.

Signal cord (not supplied)

	Pin-plug x 2	Pin-plug x 2
	LINE OUT
R	L
	LINE IN	Signal cord (not supplied)
	(AUX)

To audio input

MD recorder or

cassette deck (not supplied)

To audio output

Pin-plug x 2 Pin-plug x 2

Connecting an MD Recorder, etc. (Digital Output)

Unplug the cap and connect an optical digital cord (not supplied) between the System’s OPTICAL DIGITAL OUT terminal and the input terminal of an MD recorder, etc.

You can record the digital output signal from the System’s CD Player to the MD recorder, etc.

Cap

MD recorder, etc. (not supplied)

OPTICAL	To optical digital
	input
DIGITAL OUT	Optical digital cord (not supplied)

4