Mounting the Camera
ŸPlace the guide pattern sticker (supplied) on the mounting surface and mark three holes according to the guide pattern sticker. Then fasten the sticker to the mounting surface with screws.
ŸConnect the Safety Wire (Fall Prevention Wire, not supplied) to the camera and the ceiling.
ŸSecure the camera bottom case (1) to the wall/ceiling with tapping screws, supplied.
ŸAdjust the view angle (zoom, focus, and Horizontal Rotation).
Warning
Caution
To prevent the camera from falling off, ensure that it is connected to a firm place (ceiling slab or channel) using a Safety Wire (Fall Prevention Wire is not supplied).
Pay also careful attention to the length, strength, wiring, and material (insulating
properties) of the fall prevention wire to be used. The length should be as short as possible within the permissible range of the mounting length. The wire should be strong enough to withstand the total weight of this product. (Pay also attention to the finishing at the end of the wire.)
Must be isolated camera and the wall/ceiling which are connected by the Safety
Wire (Fall Prevention Wire).
Safety Wire
(Fall Prevention Wire, not supplied)
6