Physical Settings
|
1 | Remove the terminal cover | 5 | Remove the tape and the cap. |
and connect the fall | |||
| prevention wire. |
|
|
1 | Remove the dome cover and | 4 Mount the camera. |
take the cushioning and | ||
| protection material away. |
|
2Connect the LAN / Alarm / Power cables and tie with the wire clamp.
3Mount the terminal cover and pull out the cables from side or top.
This figure shows pulling the cable from the top.
4Mount the ceiling clamping bracket to the ceiling.
6 | Mount the dome cover and |
remove the protective sheet. |
2 Mount the dome cover.
7 | Connect the fall prevention |
wire between units, then insert | |
| the camera unit into the ceiling |
| clamping bracket. |
3 | Remove the cap and pull |
out the cables. |
810 Lock
5Connect LAN / Alarm / Power cables, then push them into the hole.
6Mount the cap and seal around the cap and mounting surface with waterproof seal.
Remove sheet.
