Setup Procedures

Step 1 Connection/Installation (A Page 16)

Connect the lens mount, power supply cord, LAN cable and alarm cable.

Next, mount the camera to the ceiling. Make sure to attach the fall prevention wire firmly to the camera. After the camera is mounted, connect the video monitor to the [MONITOR OUT] terminal at the rear of the unit, followed by adjusting the camera angle.

You can select the video signals of the [MONITOR OUT] terminal using the

[MONITOR OUT] switch. (ANTSCBor APALB) ABack Focus AdjustmentB (A Page 23) A[MONITOR OUT] Monitor Output Selection SwitchB (A Page 11)

TAfter adjusting the camera angle using the

[MONITOR OUT] terminal, set the

[MONITOR OUT] switch to AOFFB. Images

are not distributed to the network when

ANTSCB or APALB is selected. After changing the [MONITOR OUT] switch setting, press the Reset button to reboot the camera.

G

Step 2 Network settings (A Page 27)

Configure the network settings of the computer and this camera.

TIn a system where multiple units of VN-X35U are used, turn on the power of only one unit to configure the IP address settings using the Internet Explorer. Upon doing so, turn on the power of the second unit and configure accordingly. Configure the settings for the other cameras using the same procedure.

G

Step 3 Setting Using Internet Explorer (A Page 33)

Configure the picture quality and alarm settings using the Internet Explorer.

G

Step 4 Operating Built-in Viewer (A Page 86)

Built-in Viewer enables you to monitor JPEG or MPEG4 images, send/receive audio data, perform PTZ operations, and register preset positions.

15