JVC VR-609 manual Setting values of TK-C676 or TK-C655, Rx+

JVC VR-609

● Connection of RS-485 Control signal cable

VR-609
RS-485 Connector	Camera1 Connector
+	RX+	C
-	RX-	D
GND	Camera2 Connector

	RX+	C
When you install in a place with many noises,	RX-	D
please use a twisted-pair cable with a shield.
A shield cable should be connected to a GND
terminal.
	Camera9 Connector

RX+

RX-

C

D

3.3.2 Setting values of TK-C676 or TK-C655

Item	Value
Switch 4	ON
Switch 5	ON
Switch 8	Terminal equipment is set to ON.
	Other equipments are set to OFF.
ID	Install ID value independently.

●The functions can be used by this equipment are PAN/TILTE/ZOOM/FOCUS/AUTO FOCUS. (A setup of a home position, a preset position, etc. cannot be performed) In addition, in order to perform a home position setup and a camera image setup in advance, it is possible to use and set-up by remote controler of RM-P2580 grade. Please read the Instructions of RM-P2580.

●About setting values of VR-609, please refer to 5.1.2 Camera details and 5.1.3 Pan/Tilt Model Select.

●For information of other model, consult your nearest JVC dealer.

!Please connect the Pan/Tilt camera of the same protocol (Camera Setup -> Pan/Tilt Model Select -> Select Model).

-- 27 --