Before using for the first time
Installing the unit
Best location
Select a location which is level, dry and neither too cold nor too hot (temperature range 5°C to 35°C). Also, avoid dusty locations or any location subject to vibration.
If interference occurs
If this unit is placed near a tuner or a radio receiver tuned to AM frequencies, interference may occur. If this happens, we recommend either that you move this unit as far as possible from the tuner or receiver or briefly turn off the power of this unit.
Connecting to the Analog Output Jacks
Connecting to an amplifier or receiver allows you to listen to the sound from the speakers.
Connect the OUTPUT jacks of this unit to the line input jacks of an amplifier or receiver with the supplied audio cord.
NOTES•Never connect the OUTPUT jacks to the PHONO jacks of the amplifier or receiver. This may cause damage to the components.
•Make sure that the same channels are connected between this unit and the amplifier or receiver: LEFT to LEFT and RIGHT to RIGHT.
•Do not connect the power plug until all connections are complete.
•Connect the plugs firmly. Loose connections may cause noise or malfunction.
Rear panel of this unit
OUTPDIGITALTICALUTRIGHTOUTPUTLEFT | ACIN | |
|
| |
| RIGHTLEFT |
| Amplifier or receiver |
|
|
To audio input jacks
Audio cord
Speaker unit
Connecting to the Digital Output Jack
It is possible to transmit a digital sound signal from this unit directly to a MD recorder, etc.
NOTES
•Never connect the digital output cable except to the digital input jack.
•An optical digital cord (optional) is required to make this connection. Refer to the instruction manual of the MD recorder, etc. for details.
|
| Rear panel of this unit | usingBeforefor | timefirstthe | |
|
|
|
| ||
DIGITALOUT | OUTPUT | ACIN |
|
| |
OPTICAL | RIGHTLEFT |
|
|
|
|
MD recorder, etc.
Optical digital cord (optional)
|
|
|
| |
DIGITAL OUT |
|
| ||
To digital input jacks | ||||
(OPTICAL) | ||||
|
| |||
Supplying the power
To connect the AC power cord of the main unit
The AC power cord is supplied separately and must be connected to the unit.
Plug the AC power cord into the 
AC IN connector of this unit and connect to the wall outlet after all connections are complete.
NOTE
•When using the COMPU LINK Remote Control System (see page 6), do not connect the power cord to the SWITCHED AC OUTLET of an amplifier or receiver.
AC IN connector
Rear panel of this unit
DIGITAL |
| COMPU LINK - 3 | AC IN |
OUTPUT | (SYNCHRO) |
| |
OUT |
|
| |
OPTICAL | RIGHT LEFT |
|
|
Supplied AC power cord
To the wall outlet
(to be continued)
5
