JVC XU-301BK manual Troubleshooting, English, Check out the points below before, Symptom, Cause

Troubleshooting	Check out the points below before
	requesting repairs or servicing.

	Symptom	Cause	Remedial action/check	Ref.
COMMON	No sound.	• An MD with nothing recorded on it has been	• Replace the MD on which tracks have been	20
		inserted. (“BLANK DISC” is displayed.)	recorded.
	The time display flashes in the	• A power failure has occurred or the power	• Set the clock and re-program the timer.	45-47
	display window.	cord has been disconnected.
	Play fails to start	• The CD has been inserted upside down.	• Insert it properly with the label side facing	12
PLAYER			up.
		• Condensation has formed on the lens.	hours.
			• Turn on the power and wait for a couple of
CD
	Specific parts are not played	• The CD is scratched.	• Replace the CD.
	properly.
	The inserted MD is ejected.	• The MD was not inserted properly.	• Re-insert the MD by pushing it gently until	20
RECORDER			it clicks into position.
	MD cannot be inserted.	• An MD has already been inserted.	• Press the 0 button, eject the MD, and insert	21
			another MD.
	No recording.	• The MD is set to the accidental erasure	• Slide the accidental erasure prevention knob	27
MD		prevention mode (“DISC PROTECTED” is	so that the hole is blocked.
		displayed).
TIMER	Timer fails to start.	• Present time is not correct.	• Set the time properly.	45
		• The timer display ( ) fails to appear.	• Press the TIMER button so that the timer
			display ( ) appears.
REMOTE CONTROL	No remote control operations.	• The dry batteries in the remote control have	• Replace them with two fresh batteries (R03	8
		discharged.	or size “AAA”or UM4).
		• The remote control sensor is exposed to	• Operate the remote control where it will not	9
		direct sunlight or some other intense source	be exposed to direct sunlight, a lighting
		of light.	fixture or some other intense source of light.

•If the unit fails to operate properly even when the remedial action suggested above has been taken:

This unit uses a microcomputer to perform a large number of operations. If it fails to operate no matter which button is pressed, disconnect the power cord, and then wait a few moments before re-connecting it. Then set the time and re-program the timer.

If something important is going to be recorded, always test-record first to check that the recording turns out properly before proceeding with the actual recording.

The manufacturer assumes no liability whatsoever for any damages resulting from missed opportunities while conducting recording, playback or CD play operations due to malfunctioning of or trouble in the unit, or for any incidental damage.

English

55