Additional information
Troubleshooting
What appears to be a malfunction may not always be serious. Please go through the following list before requesting service.
Symptom | Possible case | Remedy | |
|
|
| |
Power does not come on. | Power plug is not inserted securely. | Plug in securely. | |
|
|
| |
| Too far from the unit. | More closer to the unit. | |
|
|
| |
| The tip of the remote unit is not pointed in | Point the infrared light- emitting window | |
Remote control does not work. | the right direction. | toward the remote sensor on the front panel. | |
|
| ||
Batteries are exhausted. | Replace the batteries with new ones. | ||
| |||
|
|
| |
| Battery polarity is incorrect. | Take out the batteries and insert them again in | |
| the correct direction. | ||
|
| ||
|
|
| |
| Connection of video cable is incorrect. | Connect the cable correctly. | |
No picture is displayed on the |
|
| |
Input selection of TV is incorrect. | Select correctly. | ||
monitor. | |||
|
| ||
| Disc is not playable. | Use a playable disc. (See page 12.) | |
|
|
| |
No picture is displayed on the |
|
| |
monitor when using the | Jack(s) at use is (are) not active. | Make them active. (See page 14.) | |
COMPONENT or | |||
|
| ||
jack(s). |
|
| |
|
|
| |
Picture is noisy. | The unit is connected to a VCR directly | Connect the unit so that the picture signal | |
and the copyguard function is activated. | flows directly to the TV. | ||
| |||
|
|
| |
No audio is reproduced. | Connection is incorrect. | Check the connections. | |
|
| ||
Input selection of amplifier is incorrect. | Select correctly. | ||
| |||
|
|
| |
No audio is reproduced when | The audio signal is not derived from the | Use the AUDIO OUT when playing back such | |
playing back a DVD disc recorded | |||
unit's DIGITAL OUT. | discs. | ||
with 96 kHz, linear PCM audio. | |||
|
| ||
|
|
| |
Sound is distorted or noise is | Disc is dirty. | Wipe the disc surface. | |
generated. | |||
|
| ||
|
|
| |
Picture does not fit the television | MONITOR TYPE is not correctly set. | Select monitor type correctly. (See page 38.) | |
|
| ||
screen. | Television is not correctly set. | Set the television correctly. | |
| |||
|
|
| |
| Microcomputer malfunction due to | Turn off the power and unplug the power | |
| lightning or static electricity. | cord, then connect the power cord again. | |
Operation is not possible. |
|
| |
Moisture condensation caused by a | Turn off the power, then turn it on a few hours | ||
| |||
| sudden change of temperature or | ||
| later. | ||
| humidity. | ||
|
| ||
|
|
|
Additional | information |
|
|
43
