JVC XV-N50BK manual Basic operations, Initial setup, Turning on/off the player

Basic operations

STANDBY indicator	0	7 3
OPEN/CLOSE	DVD STANDBY/
	ON
ENTER	5/∞/2/3
CHOICE
7	3
Basic operations	DIMMER
NOTE

Make sure that the TV - DVD switch on the

TV DVD remote control unit is set to “DVD” when using the 5/∞/2/3 and numeric buttons for controlling the player.

About invalid operation icon

When you press a button, and if the player does not accept its operation, appears on your TV screen. Operations are occasionally unacceptable even if is not displayed.

Note that some operations may not be accepted. For example, some discs may not allow rapid advance/reverse or slow- motion playback.

•CLOSE

•NO DISC

NOTE

Even if you turn off the player, the player is not disconnected from the AC power source as long as it is connected to the wall outlet. This state is called standby mode. In this state, the player consumes a very small amount of power.

Initial setup

When you turn on the player for the first time after purchase, the following message appears on the TV screen.

EXECUTE DVD PLAYER SETUP? - BASIC PICTURE/AUDIO SETTING

YES - PRESS ENTER NO - CANCEL

You can set the display language, TV monitor type and digital output before using the player, by following the procedure below.

1 Press ENTER.

The first page of the DVD PLAYER SET UP display appears. The pull-down menu of the [ON SCREEN LANGUAGE] is already open.

DVD PLAYER SET UP
MENU LANGUAGE		ENGLISH
AUDIO LANGUAGE		ENGLISH
SUBTITLE		OFF
ON SCREEN LANGUAGE		ENGLISH
		ENGLISH
		SPANISH
		FRENCH
SELECT	USE 5∞23 TO SELECT, USE ENTER TO CONFIRM
ENTER

ON SCREEN LANGUAGE options

2 Press 5/∞ to select the desired language.

You can select the on-screen language for the preference displays, etc. from among ENGLISH, SPANISH and

FRENCH.

	3 Press ENTER.
Turning on/off the player	The second page is shown, in which the pull-down menu of
	the [MONITOR TYPE] is already open.

Press DVD STANDBY/ON on the remote control unit or press on the front panel.

The STANDBY/ON indicator on the front panel, which lights in red during standby, lights in green.

The left and right sides of the display window are illuminated.

The opening display appears on the TV screen, and the following messages may appear at the bottom of the opening display.

DVD PLAYER SET UP
MONITOR TYPE		4:3 L.B.
PICTURE SOURCE		16:9 NORMAL
		16:9AUTO AUTO
SCREEN SAVER		4:3 LB
		4:3 PS
MP3&WMA/JPEG
SELECT	USE 5∞23 TO SELECT, USE ENTER TO CONFIRM
ENTER

MONITOR TYPE options

NOW READING

Message area

•NOW READING (The player is reading the disc information.)

•REGION CODE ERROR! (The region code of the DVD VIDEO disc does not match the player. The disc cannot be played back.)

•OPEN

4 Press 5/∞ to select the desired monitor type.

For a normal (conventional) TV, select [4:3 LB] or [4:3 PS]. For a wide-screen TV, select [16:9 NORMAL] or [16:9 AUTO]. (See page 27.)

8