JVC XV-NA77SL Basic operations, Initial setup, Turning on/off the unit, NOTE, NOTE, Basic, operations, 1 Press ENTER, 3 Press ENTER, About invalid operation icon

Basic operations

Basic

operations

STANDBY indicator

OPEN/CLOSE	DVD STANDBY/
	ON
TOP MENU
ENTER	5/∞
	5/∞

NOTE

Make sure that the TV - DVD switch on the

TV DVD remote control unit is set to “DVD” when using the 5/∞/2/3 and numeric buttons for controlling the unit.

About invalid operation icon

When you press a button, and if the unit does not accept its operation, appears on your TV screen. Operations are occasionally unacceptable even if is not displayed.

Note that some operations may not be accepted. For example, some discs may not allow rapid advance/reverse or slow- motion playback.

Turning on/off the unitPress DVD STANDBY/ON on the remote control unit or press on the front panel.

The STANDBY/ON indicator on the front panel, which lights in red during standby, lights in green.

The opening display appears on the TV screen, and the following messages may appear at the bottom of the opening display.

NOW READING

Message area

•NOW READING (The unit is reading the disc information.)

•REGION CODE ERROR! (The region code of the DVD VIDEO disc does not match the unit. The disc cannot be played back.)

•OPEN

•CLOSE

•NO DISC

NOTE

Even if you turn off the unit, the unit is not disconnected from the AC power source as long as it is connected to the wall outlet. This state is called standby mode. In this state, the unit consumes a very small amount of power.

Initial setup

When you turn on the unit for the first time after purchase, the following message appears on the TV screen.

EXECUTE DVD PLAYER SETUP? - BASIC PICTURE/AUDIO SETTING

YES - PRESS ENTER NO - CANCEL

You can set the display language, TV monitor type, analog audio output and digital output before using the unit, by following the procedure below.

•Refer to pages 38 and 39 for detailed explanation of each item to be set in the following procedure.

1 Press ENTER.

The first page of the DVD PLAYER SET UP display appears. The pull-down menu of the [ON SCREEN LANGUAGE] is already open.

DVD PLAYER SET UP
MENU LANGUAGE		ENGLISH
AUDIO LANGUAGE		ENGLISH
SUBTITLE		ENGLISH
ON SCREEN LANGUAGE		ENGLISH
		ENGLISH
		FRENCH
		GERMAN
SELECT	USE 5∞23 TO SELECT, USE ENTER TO CONFIRM
ENTER

ON SCREEN LANGUAGE options

2 Press 5/∞ to select the desired language.

You can select the on-screen language for the preference displays, etc. from among ENGLISH, FRENCH and

GERMAN.

3 Press ENTER.

The second page is shown, in which the pull-down menu of the [MONITOR TYPE] is already open.

DVD PLAYER SET UP
MONITOR TYPE		4:3 L.B.
PICTURE SOURCE		16:9 NORMAL
PICTURE SOURCE		16:9AUTO AUTO
SCREEN SAVER		4:3 LB
SCREEN SAVER		4:3 PS
		4:3 PS
MP3&WMA/JPEG
SELECT	USE 5∞23 TO SELECT, USE ENTER TO CONFIRM
ENTER

MONITOR TYPE options

4 Press 5/∞ to select the desired monitor type.

For a normal (conventional) TV, select [4:3 LB] or [4:3 PS]. For a wide-screen TV, select [16:9 NORMAL] or [16:9 AUTO]. (See page 38.)