References
•Remove the disc from its case by holding it at
the edge while pressing the center hole lightly.
• Do not touch the shiny surface of the disc or bend the disc.
• Put the disc back in its case after use to prevent warping.
•Be careful not to scratch the surface of the
disc when placing it back in its case.
• Avoid exposure to direct sunlight, temperature extremes and moisture.
Wipe the disc with a soft cloth in a straight line from center to edge.
•DO NOT use any solvent — such as conventional record cleaner, spray, thinner or benzine — to clean the disc.
7Cleaning the system•Stains on the system should be wiped off with a soft cloth. If the system is heavily stained, wipe it with a cloth soaked in water- diluted neutral detergent and wrung well, then wipe clean with a dry cloth.
•Since the system may deteriorate in quality, become damaged or get its paint peeled off, be careful about the following.
•DO NOT wipe it with a hard cloth.
•DO NOT wipe it strong.
•DO NOT wipe it with thinner or benzine.
•DO NOT apply any volatile substance such as insecticides to it.
•DO NOT allow any rubber or plastic to remain in contact with it for a long time.
PROBLEM | POSSIBLE CAUSE | SOLUTION | |
|
|
| |
Power does not come | The power cord and/or system cord is not connected. | Connect the power cord and system cord correctly. | |
on. |
| ||
|
|
| |
The remote control does | The batteries are exhausted. | ||
not work. |
|
| |
Sunlight is falling directly on the remote sensor. | Hide the remote sensor from direct sunlight. | ||
| |||
|
|
| |
No sound. | The system cord and/or speaker cord is not connected. | ||
|
|
| |
| The audio cord is not connected to AUX IN and/or | ||
| DIGITAL IN correctly. |
| |
|
|
| |
| An incorrect source has been selected. | ||
|
|
| |
| The decode mode is not set correctly. | ||
|
|
| |
No picture is displayed | The video cord is not connected correctly. | ||
on the TV screen. |
|
| |
The disc is not playable. | |||
| |||
|
|
| |
No picture is displayed | The scan mode is set to “PROGRESSIVE” though the | ||
on the TV screen, the | center unit is connected to the TV which does not |
| |
picture is blurred, or the | support the progressive video input such as a |
| |
picture is divided into | conventional TV. |
| |
two parts. |
|
| |
|
|
| |
Video and audio are | The disc is scratched or dirty. | Replace or clean the disc. | |
distorted. |
|
| |
A VCR is connected between the center unit and the | |||
| |||
| TV. |
| |
|
|
| |
The picture does not fit | The monitor type is not set correctly. | Set “MONITOR TYPE” properly. (A pg. 35) | |
the TV screen. |
|
| |
|
|
| |
Hard to listen to | Antennas are disconnected. | Reconnect the antennas correctly and securely. | |
broadcast because of |
| ||
noise. |
|
| |
|
|
|
42